Panorama Antennas ODP Series User manual

Installation Instruction – SW3-870
ODP-[VAR]
Introduction
A.
The ODP offset dipole antenna range provides a lightweight,
simple to install and cost effective antenna solution for fixed
radio terminals.
The antenna is suitable for external or internal use and is
supplied with an integral coaxial cable.
SW3-870 - Document Version 1.0
Mounting requirements and selecting location
B.
The antenna is designed to be fitted either on a flat, vertical surface or a mast with diameter 32mm to 54mm.
Wherever possible, the antenna should be fitted where the radiating (top) element is clear of any obstruction.
When choosing a mounting location, consider how the shortest cable run to the radio terminal can be
achieved, to minimise cable attenuation.
SW3-870 -www.panorama-antennas.com
Important Safety Note
This antenna is an electrical conductor and should
not be mounted in a location where it or the installer
may contact over-head powerlines. For locations vul-
nerable to lightning fitment of an inline surge arres-
tor should be considered.
54.0
32.0
DETAIL OF ARM / FLANGE
MOUNTING ON MAST RANGING
FROM
32.0 TO 54.0
Assemble the antenna
C.
Fit the radiating element (whip) to socket marked TOP and tighten securely.
Fit the helical counterpoise element to the lower socket and tighten securely.

Fitting the antenna
D.
Ensure that the cable exits the back of the arm in the correct direction.
Wall Mounting
Use the end of the dipole arm as a template to mark the mounting
holes, ensuring that the antenna will be vertical.
Drill holes, and secure the arm to the wall using suitable screws and
wall plugs as required. (not supplied).
Mast Mounting
The dipole arm can be secured by self-tapping screws directly into the
mast or by heavy duty, UV resistant nylon cable ties.
Routing and terminating coaxial cable(s)
E.
Route the cable away from the antenna, securing at regular intervals along the length. Care should be taken to
use correct size clips to ensure cable is not compressed. If using cable ties, these should not be overtightened.
On entry to a building or enclosure, a “drip loop” should be provided to avoid water ingress by running along the
cable.
Fit a suitable connector if not already supplied.
Commission and test
F.
Carry out a VSWR test – this should comply with value stated in product data sheet.
Connect antenna to radio terminal and carry out an “on air” check.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them
away into standard waste.
RF Safety Note
This antenna should be mounted in such a way that no person is within 30cm (12”) of the
antenna during use.
Notices
G.
RoHS 2: EU RoHS compliance is declared per Directive 2011/65/EU and its subsequent amend-
ments. Homogeneous materials composing parts that are compliant with this legislation have less
than 0.1% by weight each of lead, mercury, hexavalent chromium, PBB, and PBDE, and 0.01% by
weight of cadmium. In situations where an exemption applies, the preceding limits, corresponding
to the exempted substance(s), may be higher.
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fitness
of the products described for any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice
when planning installations and ensure that antennas are always installed by a properly qualified installer in compliance with local laws and regulations.
SW3-870 -www.panorama-antennas.com
4 HOLES
5.1