Start Your Engine Plug it into the cigarette
lighter socket Connect the High Pressure
hose to the air outlet
Connect the High
Pressure hose to the
tire
Set your desired
tire pressure Press the pump cut-o
switch to start
The pump stops automatically after reaching the desired pressure.
Remember to press the cut-o switch after it stops to prevent
the pump from starting automatically.
- Do not allow the pump to run continuously for more
than 10 mins. Allow it to cool down for 5 mins.
- Allow the Inator to cool down before detaching
the High Pressure Hose from the air outlet, as it
could be too warm to touch.
Unit Selector
Pressure Display
Decrease Pressure Increase Pressure
Unit
Power Level
The display turns o after 40 seconds. Press "R" to wake it up.
1. Three buttons operations for easy use.
2. Metal Construction pump for fast heat dissipation.
3. Quick Ination and low noise.
4. Bright LED light for convenience during low-light conditions.
5. Preset Tire Pressure and stops automatically.
- Keep out of reach of children.
- Severe injuries might occur if misused.
- High Pressure Hose at the air outlet might be hot to touch
after prolonged usage.
- Do not use it near heat sources such as the car exhaust.
- Do not use it in wet or damp environment.
- Do not use it on its side.
- Do not hold / carry it by its cord.
- Do not use it under direct sunlight, high temperature or
high pressure.
1. Do not disassemble the product.
2. Do not place it near heat sources such as the exhaust of the car.
3. It is normal for the product to heat up during use.
4. Allow the product to rest for 5 mins after using continuously for
10 mins.
All Pansky products come with a 1 year warranty.
Pansky portable tire inator is designed and manufactured
to the highest standards and delivers high quality performance,
ease of use.
If you encounter any diculties while using your
product, we recommend that you rst consult the user's manual.
If you need information or support, please visit
www.teampansky.com/warranty
Pansky Solutions LLP
22 Sin Ming Lane, #06-76 Midview City
Singapore 573969
Email: team@pansky.sg
Website: www.teampansky.com
Press "R" to switch between Units. Press "+" or "-"to preset the
desired pressure. Wait for a few seconds after setting the pressure.
After the number stops ashing, activate the pump by pressing the
pump cut-o switch. Once the desired pressure has been reached,
the pump will stop automatically. Press the cut-o switch again to
ensure that the pump is completely shut o. Failure to do that will
require the button to be pressed twice in order to reactivate the
pump again.
