Important Information
Mounting Guide
• Pleasereadtheseinstructionscompletely.
• Allinstructionsserveasaguideonlyandmustbeinstalledbyalicensedplumberin
accordancewithAS/NZS3500.1.Installationcarriedoutbyunlicensedindividualswillvoid
allwarranties.
• Supplylinesmustbeushedpriortoinstallationtoremoveanyforeignmatter.
• Allproductsaresuitableforusewithmostinstantaneoushotwaterheaters,howeverarenot
compatiblewithgravity-fedwatersystems.
• Pleasecheckallmeasurementspriortodrillingholesin
Prior to Installation:
If a bracket is supplied, position it on the wall in
the desired mounting location, preferably where
a wall noggin is located
Please Note: If there is no mounting bracket supplied for your accessory, skip to Step 2.
Drill the mounting holes to suit the plastic plugs
provided
Mark the intended mounting points. If a bracket
is supplied, do so using the bracket holes as a
template. Ensure it is positioned straight and level
on the wall.
Tap the plastic plugs into place and fit the
accessory bracket over them through the
corresponding holes.
Install screws through the plastic plugs into the
wall. where appropriate, fit locking rings or collars
over the plastic plugs before installing screws.
Install and tighten any grub screws supplied.
1.
3.
2.
4.
5.
