Paradyne 1862 Original operating instructions

1862 VoIP IAD
Quick Installation Instructions
Document Number 1862-A2-GZ10-00
November 2004
Installation
➊If you will use the USB port, install the USB driver:
– Insert the CD in your CD-ROM drive
– Browse to the USB Driver directory
– Start setup.exe
– Follow the instructions on your screen
➋Connect the power adapter to the Power jack of the IAD,
then plug the power adapter into an AC wall outlet.
➌Connect the FXS port of the IAD to your analog telephone with an RJ11 connector cable.
➍Optionally, connect the USB port of the IAD to a free USB port on your PC with a standard USB cable.
➎Alternatively, connect the LAN port of the IAD to your PC's Ethernet port, or to an Ethernet switch or hub, with an RJ45 cable.
➏Connect the ADSL port to the wall outlet, a POTS splitter, or micro filter (consult your service provider), with an RJ11 connector cable.
➐Turn on the power switch on the rear panel.
Using the Web Interface
Configuration of the Gateway is performed using its integral web interface. To use the web interface, start your Internet browser. Type
the default IP address for the Gateway into the address field: http://192.168.1.101 Enter the default username root and the default
password 1234 when prompted. Your PC must be on the same subnet as the Gateway. See the user’s guide on the CD for details. 1
*1862-A2-GZ10-00*
*1862-A2-GZ10-00*
LAN LINEUSBFXS
PowerOn
Off
04-17597
Power
Switch
AC Power
Input VoIP Service
USB
PC/LAN
To POTS
Splitter,
Micro Filter
or
W ll Outlet
Copyright ©2004 Paradyne Corporation. Printed in U.S.A.