Paris Rhone PE-TF022 User manual

Questions or Concerns?
[email protected]
TABLE AIR
CIRCULATOR FAN
PE-TF022
User Manual

THANK YOU
FOR BEING OUR CUSTOMER
Your purchase is truly appreciated!
We hope you are over-the-moon with our product!

SAFETY
INSTRUCTIONS
01
CONTENTS
SAFETY INSTRUCTIONS
KNOWING YOUR TABLE AIR CIRCULATOR FAN
USING YOUR TABLE AIR CIRCULATOR FAN
CLEANING AND MAINTENANCE
TROUBLESHOOTING

INTENDED USE
· This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
· Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
· Use the appliance only for intended household purposes as described in this User Manual. Any other use is not
recommended that may cause fire, electric shock, or injury to people.
ELECTRICITY SAFETY
· This appliance must be provided with correct voltage via a professionally installed power socket. Make sure the
voltage indicated on the label of the appliance is the same as your local supply.
· If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
· Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.
Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not
be tripped over.
RELATED TO USE
· DO NOT use this fan to ventilate areas where flammable liquids or vapors are used, stored or are present.
· DO NOT attempt to disassemble, repair, modify or replace any part any part of your product.
· Always make sure to place the fan on a flat, level surface before operation.
· Always unplug the appliance before cleaning, making any repairs or servicing, or whenever not in use.
· It is normal that there is noise during operation. If too loud, please set the fan to lower speed.
BEFORE USING THIS
APPLIANCE READ ALL
INSTRUCTIONS AND
CAUTIONARY MARKINGS
IN YOUR USER MANUAL
AND ON THE APPLIANCE
DANGER FOR HOUSEHOLD USE ONLY
HAVE YOUR TOWER FAN CHECKED
REGULARLY FOR ANY SIGN
OF MALFUNCTION!
Stop using, check FAQ and contact Paris Rhône Support Team.
Check if plug, cord or appliance is damaged
SPECIFICATIONS
Input
Rated Power
120V 60Hz
40W
Regular Check
DO NOT touch or hold the
mains plug with wet hands.
DO NOT block or cover air
flow to or from the fan while
in operation.
DO NOT insert fingers or
objects through the grille
while in operation.

KNOWING YOUR
TABLE AIR
CIRCULATOR FAN
02
A: Carry Handle
B: Air Outlet
C: LED Display
D: Control Panel
E: Base
F: Air Inlet
G: Power Cord
H: Remote Control
H
C

Power ON/Standby
· Tap to start/stop horizontal
oscillation.
· You can manually adjust the
tilt angle (up & down) to
change the air flow.
Timer for Turning OFF
Tap to set timer for turning
off the fan (0-8h).
Fan Speed
Tap to cycle through
1-3 fan speed.
Power ON/Standby
Turn on / Standby mode.
Control Panel
USING YOUR
TABLE AIR
CIRCULATOR FAN
03

LED Display
Remote Control
For added convenience, the same control buttons can be found on the remote
control (except for )
Fan Speed
Timer Settings
Display ON/OFF
Oscillation
Power ON/OFF
Additional Features
Memory Function
The fan is designed with power off memory function, it will always
remember your last settings (except timer setting) once you turn it on
again. If the fan is disconnected, it will resume to the default mode
(Level 12 fan speed, oscillation off) the next time you turn it on.
User Servicing Instructions
This Tower Fan features a fused safety plug which is designed to cut off electric
current to the fan if an electrical fault occurs. If your fan loses power and you
suspect that the fuse on your fan has blown,
1
2
3
2
1
34
4
Grasp plug and remove from the receptacle or other outlet device.
DO NOT unplug by pulling on cord.
Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
Remove fuse carefully. Insert the tip of your tool into fuse slot (close with the terminal), then
prize the fuse gradually and slowly, but not overexert. If you feel tight, you can try it at
several times and prize the fuse little by little. When one side of the fuse has been prized,
then you can get the fuse out entirely. Risk of fire. Replace fuse only with 5 Amp,
125 Volt fuse.
Close fuse cover. Slide closed the fuse access cover on top of attachment plug. Risk of fire.
DO NOT replace attachment plug. Contains a safety device (fuse) that should not be
removed. Discard product if the attachment plug is damaged.
Timer
Oscillation Power ON
Fan Speed / Timer
Fan Speed

Replacement of Batteries
2
1
3
Press the locking button to pop up the battery holder.
Replace the battery with the same type (CR2025, 3V), making sure the (+) side facing up.
Push in the holder until securely locked into place.
1
2
3
·Replace with new batteries of the same type when replacement is required.
·When not using the remote control for a long time, please take out the batteries.
·DO NOT attempt to dismantle the batteries.
·DO NOT dispose the batteries in fire, batteries may explode or leak.
·DO NOT use rechargeable batteries.
Do not ingest battery, Chemical Burn Hazard. This product contains a coin / button
cell battery. If the coin / button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death. Keep new and used batteries away from
children. If the battery compartment does not close securely, stop using the product
and keep it away from children. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention. The batteries
contain materials, which are hazardous to the environment; they must be removed
from the appliance before it is scrapped and that they are disposed of safely.
WARNING:
CLEANING AND
MAINTENANCE
04

· Always make sure the tower fan is turned off and unplugged before cleaning.
· DO NOT stick any foreign objects or your fingers inside of the unit.
· Never immerse in water or allow water to drip into the motor housing.
· DO NOT clean with abrasive chemicals or flammable cleaning agents.
For storage, you may leave the tower fan covered to protect it from dust.
Store it in a cool, dry location and wrap the cord around the cord wrap on the
unit so that it will not be tripped over or damaged.
Only a soft cloth can be used for
cleaning the outer surfaces.
To remove dust between the grills,
a pipe cleaner, flexible dust wand,
vacuum cleaner or compressed air
are acceptable.
TROUBLE-
SHOOTING
05

WEEE Compliance
Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
(Applicable in countries with separate collection systems)
This marking on the product, accessories or literature indicates that the product and its
electronic accessories should not be disposed of with other household waste at the end of their
working life. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate these items from other types of waste and recycle them
responsibly to promote the sustainable reuse of material resources. Household users should
contact either the retailer where they purchased this product, or their local government office,
for details of where and how they can take these items for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase
contract. This product and its electronic accessories should not be mixed with other commercial
wastes for disposal.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Why there is noise It is normal that there is noise during high speed,
lower the speed and check again.
QA
Why the wind
power is not
strong enough
·Move the fan closer.
·Ensure air inlet and outlet are unobstructed,
and no obstacles before the fan.
Why the remote
control is not
working
·Make sure the fan is connected to a powered
electrical outlet.
·Check that the remote control is powered and
move the obstacles between the fan and the
remote.
·Operate the remote control near or in front
of the fan.

Intertek
4005910
CM
[email protected]
Manufacturer: Shenzhen Danya Technology Co.,Ltd.
Address: Room 705, Building E, Galaxy World Phase II, Minle Community,
MinZhi Street, Longhua District, Shenzhen, China
www.parisrhone.co
MADE IN CHINA
Rev_1.0_EN

尺寸：140*210mm
装订成册
材质：封面120克铜版纸，内页80克书纸
印刷：双色印刷