PASCO PS-3599 User manual

Instruction Sheet
012-16144A
800-772-8700 www.pasco.com
Wireless Sensor Charging Station
PS-3599
Introduction
The PS-3599 Wireless Sensor Charging Station provides
an organized way to charge all types of PASCO wireless
sensors. Up to ten PASCO wireless sensors can be
charged simultaneously. The charging station can be
configured to fit any size sensor by adding or removing
the included dividers.
Operation
Installing a plug into the power supply
After unboxing the Wireless Sensor Charging Station for
the first time, insert the plug corresponding to your
electrical receptacle into the power supply (Figure 1).
Figure 1: Insert a plug into the power supply.
How to charge PASCO wireless sensors
1. Connect the power supply to the power input jack
on the charging station (Figure 2).
2. Connect the power supply to an electrical
receptacle outlet.
3. Connect a USB cable to any USB A port on the
charging station (Figure 2) then connect the other
end of the cable to a sensor.
4. Place the sensor into the charging station and
insert a divider to create a partition (Figure 3).
5. Repeat steps 3 and 4 for up to nine additional
wireless sensors.
Figure 2: Rear View of the Wireless Sensor Charging Station

PS-3599 Wireless Sensor Charging Station
012-16144A
Figure 3: Various sensors placed in the charging station with
the USB cables connected
Battery charging status
When connected to power, the battery LED on each
sensor indicates the charging status of the sensor:
Battery LED
Charging Status
Yellow solid
Battery is charging
Green solid
Battery is fully charged
Storage
Sensors can be stored in the charging station for long
periods of time without harming the battery. The sensor
circuitry monitors the battery level and will start charging
the unit when it falls below a certain level. When the
battery is fully charged, the sensor circuitry will stop
charging the unit.
Technical Support
For assistance with PASCO products, contact PASCO at:
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone:
916-462-838
Web:
www.pasco.com
Email:
[e-mail]
Product End of Life Disposal Instructions
This electronic product is subject to disposal and recycling
regulations that vary by country and region. It is your
responsibility to recycle your electronic equipment per
your local environmental laws and regulations to ensure
that it will be recycled in a manner that protects human
health and the environment. To find out where you can
drop off your waste equipment for recycling, please
contact your local waste recycle/disposal service, or the
place where you purchased the product.
The European Union WEEE (Waste
Electronic and Electrical Equipment) symbol
on the product or its packaging indicates that
this product must not be disposed of in a
standard waste container.
More Information
For more information about the latest revision of this
Instruction Sheet or any PASCO product, visit
www.pasco.com/manuals
and enter the Product Number.
Warranty, Copyright, and Trademarks
Limited Warranty For a description of the product
warranty, see the PASCO catalog.
Copyright The PASCO scientific 012-16144A Wireless
Sensor Charging Station Instruction Sheet is copyrighted
with all rights reserved. Permission is granted to non-profit
educational institutions for reproduction of any part of this
manual, providing the reproductions are used only in their
laboratories and classrooms, and are not sold for profit.
Reproduction under any other circumstances, without the
written consent of PASCO scientific, is prohibited.
Trademarks PASCO and PASCO scientific are
trademarks or registered trademarks of PASCO scientific,
in the United States and in other countries. All other
brands, products, or service names are or may be
trademarks or service marks of, and are used to identify,
products or services of, their respective owners. For more
information visit www.pasco.com/legal.