Patron APOLLO DISPENSER User manual

1 notch = 0.01 mL
1 full rotation = 0.15 mL
Extracts have different specific gravities, usually ranging from 1.05 - 0.95 g/mL
HOW TO DISPENSE
Bring the level of oil to the tip of the nozzle. This step is achieved by
gradually turning the threaded piston in a clockwise direction. Now
that the oil is at the surface of the nozzle create your dose by following
the guidelines above.
Always remember to release the pressure
in the system by backing off the gasket.
To achieve this important step turn the
piston in a counter clockwise
direction, until the piston is
not engaged with the gasket.
USER MANUAL
Threaded Piston
Piston Housing with metering scale
Pressure Fitted Gasket
BIA 2 mL / 5 mL Cartridge*
APOLLO Steel Casing
NYX Titanium Nozzle**
Dispensing Nozzle
Nozzle Cover
Cartridge Cap
* Pictures are aplicable to 2 mL and 5 mL cartridges
** Included with APOLLO Dabber
1 line-to-line
1/3 of a turn = 0.05 mL
Dosing guidelines
1 notch
1 line-to-line (3/1 of a turn)
1 full turn
0.01 mL
0.05 mL
0.15 mL
APOLLO
DISPENSER /DABBER

1 2 3 4
Remove the cartridge cap from the
cartridge. Firmly install the dispensing
nozzle**. It is important to install the
nozzle outside of the Steel casing.
** In APOLLO Dabber install NYX Nozzle.
Disassemble your APOLLO. Insert
the cartridge into the steel casing.
Assemble casing, housing disc and
threaded piston.
To dispense the product slowly turn
the piston clockwise. Each notch on
the scale dispenses 0.01 mL. Wait a
few seconds to dispense desired
amount of extract if using thicker
materials.
For storage turn the piston
counter-clockwise. It is important to
back the piston right off the gasket to
remove all pressure from the system.
After that place the nozzle cover on
the nozzle.
Assembly guidelines
Pictures and instructions are applicable to APOLLO Dispenser and APOLLO Dabber 2 mL or 5 mL.
Caution: Dropping APOLLO may result in nozzle breakage. Store dispenser / dabber properly after use.