Patron EOS DISPENSER User manual

1
l
i
n
e
=
0
.
0
5
m
L
1 notch = 0.01 mL
Extracts have different specific gravities, usually ranging from 1.05 - 0.95 g/mL
HOW TO DISPENSE
Bring the level of oil to the tip of the nozzle. This step is achieved by
gradually turning the threaded piston in a clockwise direction. Now
that the oil is at the surface of the nozzle create your dose by following
the guidelines above.
USER MANUAL
Threaded Piston
Piston Housing with scale
Pressure Fitted Gasket
BIA 2 mL / 5 mL Cartridge*
Dispensing Nozzle
Nozzle Cover
Cartridge Cap
*Pictures are aplicable to 2 mL and 5 mL cartridges
Dosing guidelines
1 notch
1 line-to-line (1/3 of a turn)
1 full turn
0.01 mL
0.05 mL
0.15 mL
EOS
DISPENSER
Always remember to release the pressure in
the system by backing off the gasket. To
achieve this important step turn the piston
in a counter clockwise direction, until the
piston is not engaged with the gasket.
1 full rotation = 0.15 mL

1 2 3 4
Remove the cartridge cap from the
cartridge. Firmly install the dispensing
nozzle.
Assemble your EOS. Assemble
casing, housing disc and threaded
piston.
To dispense the product slowly turn
the piston clockwise. Each notch on
the scale dispenses 0.01 mL. Wait a
few seconds to dispense desired
amount of extract if using thicker
materials.
For storage turn the piston
counter-clockwise. It is important to
back the piston right off the gasket to
remove all pressure from the system.
After that place the nozzle cover on
the nozzle.
Assembly guidelines
Pictures and instructions are applicable to EOS Dispenser 2 mL or 5 mL.
Caution: Dropping EOS Dispenser may result in nozzle breakage. Store dispenser properly after use.