PB TEEN BEADBOARD FULL User manual


Date:2013-May-30 www.pbteen.com Page 1 of 3
Rev:



BEADBOARD DAYBED
(FULL / TWIN)
ASSEMBLY INSTRUCTIONS















































Date: 2013-May-30 www.pbteen.com Page2of3
Rev:


Important Safety Instructions:
• Please read all instructions carefully before assembling this bed.
• For your safety, assembly by two or more adults is strongly recommended.
• Keep these instructions for future use.
• Use only vendor-supplied hardware to assemble this item. Using unauthorized hardware could jeopardize the
structural integrity of the item.
Pre-assembly:
• Remove all parts and hardware from the box. Place them on a carpeted or scratch-free work surface, as this
will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
• To avoid accidentally discarding small parts or hardware, do not dispose of any packaging or contents of the
shipping carton until assembly is complete.
• Use the parts and hardware lists below to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
• The use of power tools to aid in assembly is not recommended. Power tools can damage the hardware and
split the wood.
Parts Included:
(A) Back Panel (1x)
(B) Left Side Headboard (1x)
(C) Right Side headboard (1x)
(D) Side Rail (1x)
(E) Slat Roll (1x)
Hardware Included:
(F) Allen Key – 1x (G) Bolt 1/4”x 45mm – 4x (H) Half Moon Washer – 4x
(I) Spring Washer ¼” – 4x (J) Flat Washer ¼” – 4x (K) Wood Screw 4x30mm – 28x
Tools Required (not included):
Philips Head Screw Driver


Date: 2013-May-30 www.pbteen.com Page3of3
Rev:


Assembly Instruction Steps:
1. Attach the Left & Right Headboards (B&C) to the Back Panel (A).
2. Secure with 4 sets of: Bolts (G), Spring Washer (I), Flat Washer (J), and Half-Moon Washer (H) from the cut-outs
on the Back Panel (A) and into the metal inserts located on the Left & Right Headboards (B&C).
3. Loosely tighten the bolts with Allen Key (F).
4. Hook the Side Rail (D) to both of the Headboards (B&C) with the solid ledge facing inside, as seen in the
illustration below.
5. Tighten all bolts after the side rail is in place.
6. Place Slat Roll (E) into the bed frame.
7. Secure with 28 Wood Screws (K) by using a Phillips Head Screwdriver (not included).















Care Instructions:
•Dust often using a clean, soft, dry, and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp cloth.
•We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
•Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
J
I
F
G 4x
I 4x
J 4x
H 4x
G
K
28x