PB TEEN Sleep & Study Loft Bed CD Shelf User manual

Date – 02-July-2012 www.pbteen.com Page 1/3
Sleep & Study Loft Bed – CD Shelf
PRE-ASSEM LY:
• For your safety and ease, assembly by two adults is recommended.
• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the assembly instructions.
• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping
box provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid
accidentally discarding small parts or hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting assembly.
• Note: DO not fully tighten the bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.
• Do not use power drill as it may cause cracking.
Assembly Instruction
s
2
of 4

Date – 02-July-2012 www.pbteen.com Page 2/3
HARD ARE LIST
(C8) Allen Key – 1x
(C9) Long olt 1/4”x45mm – 3x
(C10) Short olt 1/4“x28mm – 11x
(C11) Spring Washer – 14x
(C12) Flat Washer – 14x
(C13) Shelf Supporter – 4x
ASSEM LY INSTRUCTIONS:
1. Slide a Spring Washer (C11) and a Flat Washer (C12) onto each Long olt (C9) and Short olt (C10).
2. Attach and connect Front Rail (C5), Rear Rail (C4) and ottom Panel (C7) to pre-drilled holes located on the
Left Side Panel (C2). Insert Short olts with washers from wooden cleats into insert nuts located on the Left
Side Panel. Note: Front/Rear Rail is secured by one Short olt while the ottom Panel is by two Short olts.
Attach Right Side Panel (C3) onto the assembled piece. Repeat previous steps to secure the Right Side
Panel by using (4) Short olts (C10).
C3.
C8.
C11.
C12.
C10.
C2.
C7.
C4.
C5.
C8.
C11.
C12.
C10.
C3.
C2.
C5.
C6.
C7.
C4.
C1.
PARTS LIST:
C1). Top Panel – 1pc
C2). Left Side Panel – 1pc
C3). Right Side Panel – 1pc
TOOLS REQUIRED: Philips Screwdriver (Not included)
C4). Rear Rail (Narrow) – 1pc
C5). Front Rail (Wide) – 1pc
C6). Shelf – 1pc
C7). ottom Panel
–
1pc
C10
4
x
C10
4
x

Date – 02-July-2012 www.pbteen.com Page 3/3
3. Place the assembled piece in upright position. Attach Top Panel (C1) onto the assembled piece. Insert (3)
Short olt (C10) with washers from bottom of wooden cleats located on the Front Rail (C5) into Top Panel
(C1). Insert (3) Long olt (C9) with washers from bottom of Rear Rail (C4) into Top Panel. Check alignments
and tighten all connecting bolts.
4. Insert (4) Shelf Supporters (C13) onto corresponding holes inside the cubby and place Shelf (C6) onto the
shelf supporters.
5. Assembly of CD Shelf component completes.
CARE INSTRUCTIONS:
• Dust with a clean, soft cloth.
• Avoid the use of chemicals and harsh cleaning agents.
C6.
C6.
C13.
C10
3
x
C9
3x
C13
4x