PB TEEN Greta User manual

Greta Poster Bed – Queen Size
PRE-ASSEMBLY:
•Please read all instructions carefully before assembly.
•For your safety and ease, assembly by two adults is recommended.
•Save all packing materials until assembly is complete to avoid accidentally discarding small parts or
hardware.
•Do not use a power drill as it may cause cracking.
PARTS INCLUDED:
A- Headboard (1pc) B- Footboard (1pc) C- Slat (1pc)
D- Side Rail (2) E- Footboard Long Post (2pcs) F- Headboard Short Post (2pcs)
G- Round Finials (4pcs) H- Center Support Rail (1pc) I- Center Leg (3pcs)
HARDWARE INCLUDED:
J- Long Screw (32pcs) K- Short Screw (4pcs)
TOOLS REQUIRED (but not included):
•Phillips Head Screwdriver
www.pbteen.com
1 of 3

ASSEMBLY:
1. On a soft, scratch-free surface, such as a carpet or rug, remove all the parts from the boxes.
2. Hold the Headboard (A) in a vertical position tilted slightly forward. Attach each Side Rail (D) to the
Headboard (A) by inserting the hooked ends of the Side Rail (D) into the corresponding slots in the
Headboard (A) as shown below in Figure 1.1. Push down firmly on the top of the Side Rail (D) until they
seat themselves securely into the Headboard (A). Repeat with Footboard (B). Please Note: There are two
levels for the Side Rail (D); make sure the Side Rail (D) is on the same level for both the Headboard (A)
and Footboard (B).
3. Thread Center Legs (I) with levelers into the pre-drilled holes on the bottom of Center Support Rail (H) as
shown below in Figure 1.2.
4. Place the Center Support Rail (H) onto the metal brackets located on Headboard (A) and Footboard (B).
Please Note: If you placed the Side Rails (D) in the highest level on the Headboard (A) and Footboard (B),
unscrew the metal bracket on the Headboard (A) and Footboard (B) and then re-attach to the upper pre-
drilled holes.
5. Fasten Center Support Rail (H) into place by screwing the Short Screw (K) through the pre-drilled holes
on the Center Support Rail (H) and into the metal brackets on Headboard (A) and Footboard (B) as shown
below in Figure 1.3.
6. Adjust the recessed levelers located at the bottom of each Center Leg (I) by turning the levelers counter-
clockwise until adequate contact is made with the floor.
Figure 1
Figure 1.3
Figure 1.1
Figure 1.2
www.pbteen.com
2 of 3

7. Lay Slat Rail (C) on the inner edges of the Side Rails (D), insert Long Screws (J) into the pre-drilled holes
on the Slat Rail and into the Side Rails (D); tighten using a Phillips Head Screwdriver as shown below in
Figure 2.1.
8. There are 2 options for decorating this bed: Posts Decoration – place Footboard Long Post (E) on
Footboard (B) and tighten by turn clock-wise. Repeat with Headboard Short Post (F) on Headboard (A).
Finials Decoration – place Round Finial (G) on Headboard (A) and Footboard (B), tighten by turn clock-
wise as shown below in Figure 2.2.
Figure 2
Figure 2.2
Figure 2.1
CARE INSTRUCTIONS:
•Avoid direct sunlight and excessive temperatures.
•Dust often using a clean, soft, dry and lint-free cloth
•Waxing is not recommended on lacquered finish
www.pbteen.com
3 of 3