PB TEEN MAISON BOOKCASE User manual


Date:9‐Apr‐15www.pbteen.com  Page1of6
Rev:  7‐Dec‐15





















MAISON BOOKCASE





Date:9‐Apr‐15www.pbteen.com  Page2of6
Rev:  7‐Dec‐15
Important Safety Instructions:
Please read all instructions carefully before assembling.
For your safety, assembly by two or more adults is strongly recommended.
Keep instructions for future use.
Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as
this will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
Use the parts and hardware lists below to identify and separate each of the pieces included.
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
Parts Included:
(A) Side Frame 2x
(B) Shelf (with holes) 2x
(C) Shelf 2x
(D1) Back Rail 1x
(D2) Back Rail 1x
(E) Top Support 4x
(F) Top Frame 1x
(G) Finial 4x
Hardware Included:
(H)
Bolt
Dia. 6 x 13
mm
(I)
Short Bolt
Dia. 6 x
10mm
(J)
Nut
(K)
Bracket
(L)
Nylon Strap
(M)
Screw
Dia.4 x
38mm
(P)
Flat
Washer
20x 9x 9x 2x 2x 4x 4x
Tools Required (included):
(N) Allen Wrench 4mm (O) Open Wrench
A
A
B
C
D1
E
B
F
G
C
D2
E


Date:9‐Apr‐15www.pbteen.com  Page3of6
Rev:  7‐Dec‐15
Assembly Instruction Steps:
1. Attach Shelves (B and C) to Side Frame (A) as shown, insert 13mm Bolt (H) and tighten with Allen Wrench (N).





























C
A
A
B
C
B
N
H
B
The holes on both Shelf (B)
should face to the same side.


Date:9‐Apr‐15www.pbteen.com  Page4of6
Rev:  7‐Dec‐15
2. Attach Back Rail (D1) (D2) to the back, fix with 10mm Bolt (I) and Nut (J) and Flat washer (P), tighten by hand
at first, and then tighten with Allen Wrench (N) and Open Wrench (O).














































I
D1
J
O
N
NOTE: The holes on
Back Rail (D) are facing
to back.
O
J
D
I
N
N
I
P
J
O
4X
1X
4X
D1
D2


Date:9‐Apr‐15www.pbteen.com  Page5of6
Rev:  7‐Dec‐15
3. Insert the Top Support (E) into the top of Side Frame (A), insert the 13mm Bolt (H) as shown, tighten by Allen
Wrench (N). But be sure not to fully tighten all the bolts at this point.























4. Attach Top Frame (F) to Top Support (E), Screw in Finials (G), tighten by hand. Finally, fully tighten all bolts.
Adjustable levelers are installed to accommodate uneven flooring. To adjust these levers, simply turn them
clockwise to up or counter clockwise to down.
NOTE: USE THE ANTI-TIP KIT PROVIDED TO SAFELY SECURE YOUR PRODUCT(S). FOLLOW THE
INSTRUCTIONS PROVIDED TO PREVENT SERIOUS INJURY FROM TIPPING FURNITURE.
Care Instructions:
Dust often using a clean, soft, dry and lint-free cloth.
Blot spills immediately and wipe with a clean, damp, cloth.
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary. 
Thankyouforyourpurchase
Stores|catalog

A
E
E
E
E
E
A
H
N
G
F
G
G
G


Date:9‐Apr‐15www.pbteen.com  Page6of6
Rev:  7‐Dec‐15
Imported by / Importé par / Importado por
WILLAMS-SONOMA INC.
3250 Van Ness, SF CA 94109, US
CANADIAN DISTRIBUTION ADDRESS/ ADRESSE DE DISTRIBUTION CANADIENNE / DIRECCIÓN DE DISTRIBUCIÓN EN CANADÁ:
3401 Dufferin St. Space 215, Toronto, Ontario, M6A 2T9, CA

FURNITURETIPPINGRESTRAINT

WARNING:Thisproductisonlyadeterrent.Itisnotasubstituteforproperadultsupervision.Manufacturer
assumesnoliabilityforimproperinstallationorexcessiveloadsplacedonscrews,bracketsorstraps.

Youngchildrenmaybeinjuredbytippingfurnitureandtheuseofatippingrestraintishighlyrecommended.

Whenproperlyinstalled,thisrestraintwillprovideprotectionagainsttippingoffurniture.Thistippingrestraint
MUSTbesecuredtoawall‐studorwallstructureofsimilarstrength.


Hardwareincluded:
(K)Brackets2x(L)NylonStrap1x(M)StudMountingScrews4x

Note:Forsafemountingitisessentialtousetheproperhardwareforyourwalltype.Theincludedhardwareisfor
drywallorstudmountingonly.Forotherwalltypes(e.g.,plaster,concreteandbrick)pleaseconsultyourlocal
hardwarestoreforfasteneradvice.

Toinstall:

1) LOCATINGTHESTUDS:Useastudfindertolocatetheverticalwoodenstudswithinyourwalllocated
behindthefinalpositionofthefurnitureitem.Markthestudlocationswithalightpencil‐mark.

2) MOUNTINGTHEFURNITURE‐SIDEBRACKET:Movethefurnitureitemclosetothewalltoitsfinalposition.
Usepiecesoftapeorapenciltotranscribethestudlocationsofthewall.Movethefurnitureitemagainsoyou
canaccessitsback.

3) MOUNTINGTHEWALL‐SIDEBRACKET:Positionthebracketalongtheselectedstudmarksothatitwillbe
adjacentthefurniturepostwhenthefurnitureitemismovedtoitsfinalposition.Thebracketshouldbeabout
TWOincheslowerthanthe1stLayertop.UsetheTWOStudMountingScrewstosecurethebrackettothewall.
Remembertopositionthebracketverticallysothatbothscrewswillengagetheselectedwallstud

4) ATTACHINGTHESTRAP:Whenbracketissecurelyattached,movethefurnituretoitsfinaldesiredposition
andthreadthestrapthroughthebracketasshown.Tightenthestrapuntilseveral“clicks”areheard.The
furnitureitemisnowsecurelytetheredtothewall.

Note:Ifyoumustmovethefurnitureitem,youcanreleasethestrapbydepressingtheleverarmlocatedatits
buckleandsimultaneouslywithdrawingthestrapfromthebuckle.Makesuretoreconnectthestraponcethe
furnitureitemisreturnedtoitspreviousposition.


M
L
K