PB TEEN Wall Mounted Lighted Up Mirror User manual

Wall Mounted Lighted Up Mirror
Important Safety Information:
These instructions are provided for your safety. It is very important that they are read carefully and completely before
beginning the assembly of this lighting fixture.
This product has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.
This fixture has been rated for up to (16) 5-watt maximum (Type G) standard incandescent light bulbs(included). To
avoid the risk of fire, do not exceed the recommended bulb wattage.
Warning:
To reduce the risk of fire, electrical shock or personal injury, always turn off the light fixture and unplug.Allow it to
cool prior to replacing any of the 16 light bulbs.
Do not touch any of the bulbs when they are lit as they will be hot.
Keep flammable materials away from a lit bulb.
This lighting fixture contains lead, a chemical known to the State of California to cause cancer, birth defects and
other reproductive harm. Wash your hands after installing, handling, cleaning or otherwise touching this light fixture.
Parts Included:
(A) Paper Template (D) Keyhole
(B) Wall Anchors – 2pcs (E) Wall Mounted Light Up Mirror Lighting Fixture
(C) Screws – 2pcs (F) 18 – Type G 5-watt bulbs (incl. 2 extra bulbs)
Mounting Instructions:
1) Decide on an orientation and a mounting location. Hold the provided paper template (A) against
the wall in the selected orientation and location and then use a pencil to mark the wall through
the paper template at the two keyhole locations for that particular orientation. The two resulting marks on the wall
will be the locations for the mounting hardware.
2) If either of the two marks of Step (1) aligns with a wall stud (use a stud-finder to determine this), use a
screwdriver to secure a screw (C) at this mark directly into the wall and stud - do not use an anchor (B) at the stud
location. Rotate the screw clockwise until the screw head is about 3/8” from the wall. This protruding portion of the
screw will engage one of the two keyholes located on the back of the item.
3) For marks that do not align with a stud, use a Phillips screwdriver to install an anchor (B) into the wall.
To do this, position the tip of the anchor against the wall at one of the marks and then gently push the
anchor into the wall as you rotate it clockwise. The anchor is designed to drive itself into the wall as it is
rotated. Continue rotating the anchor until the wide end becomes even with the surface of the wall.
Repeat this step with the other anchor and non-stud aligning mark.
4) Use the screwdriver to secure a screw into each installed anchor. Rotate the screw clockwise until the
screw head is about 3/8 inches from the wall.

5) Before mounting the lighting fixture on the wall, carefully insert all 16 of the Type G 5-watt bulbs (F) into the fixture’s
sockets (then take a break).
6) Preferably with the help of another person,lift the lighting against the wall so that the two selected keyholes align
With and engage the protruding screw heads. Gently lower the item so that the screws support its full weight. Make
sure that each screw is completely engaged with its keyhole before releasing the item.
7) Plug the cord of the lighting fixture into a proper electrical outlet and test the fixture.
Care Instructions:
Wipe clean using a soft, dry cloth or static duster. Do not use strong chemical or abrasive cleaners.
Thank you for your purchase.
www.pbteen.com