LOW TEMP:
HIGH TEMP:
550-600℉
750℉+
*Do not exceed 900℉
UNIVERSAL JOINT
HEAT SHIELD
HEATING COIL
HYBRID QUARTZ DISH
NUT
Due to environmental conditions the
temperature between the coil and nail
can vary by 100 degrees or more.
*NOTE:
TROUBLESHOOTING:
If the display box reads ‘E44’ there’s an issue with
the coil. A new coil will resume proper function.
DON’T:
Do not use the coil near fabrics or paper
products.
Do not modify the control box.
Do not twist, stretch or try to manipulate the
heating coil cord.
Do not leave the unit powered on for
extended periods of more than 2 hours.
Do not leave the unit on unattended.
Do not leave the carb cap on the nail while
the heating coil is attached.
Do not attempt to clean the unit while
powered on.
Do not operate around volatile or flammable
materials.
CAUTION:
This unit is a fire hazard, please operate with
extreme caution. The coil is capable of reaching
upwards of 1,000℉and can cause serious injury
and burns, or permanently damage property.
Never leave on or unattended.
REGISTER:
Fill out this quick form to streamline
any warranty claims and receive a
sticker pack from us!
yodabbadabba.com/warranty
MAINTENANCE:
Check out our FAQ Page for tips on
routine maintenance and more
information.
yodabbadabba.com/dabbing-resources/enail-faq
HOW TO ASSEMBLE
To attach the quartz dish to the
titanium base: unscrew the top nut,
place the coil on the heat shield, secure
the hybrid dish, and screw the top nut
back on. See the illustration to identify
parts.
Line up the arrow on the coil connector
with the push button on the control box
and attach.
Hold down the middle button on the
control box to power on.
Use the up and down arrows to adjust
the temperature setting until your
desired temperature is displayed.
DO:
Ensure the coil is secure before use.
Keep the coil and unit away from liquids.
Allow the coil to fully cool, naturally, before
handling or storing.
Only use compatible Yo Dabba Dabba
accessories.
Keep away from children and pets.
Know your state laws.
Grip the coil at the base when removing from
the unit.
AUTO SHUT OFF:
The default auto-shutoff time is 2 hours.
To modify, press the middle button on the
control box 5 times and use the up and down
arrows to adjust the time from 0-5. Setting the
number to 0 will turn off the function, and 5 will
turn the unit off after five hours.
A
B
C
D
WHAT’S IN
THE BOX
A. FLAT COIL
B. CONTROL BOX
C. 6-N-1 HYBRID NAIL
D. POWER CORD
E. CARB CAP
F. QUARTZ DISHES
E
F
