PDQ 6300 User manual

1
40" To Finished Floor
6300/6400R/RF EXIT INSTALLATION INSTRUCTION
RIM DEVICE Phone: 833-2-PDQTEC | www.pdqlocks.com
2. SIZE DEVICE
 Standard lengths are for 36" or 48" door.
Device must be cut for other lengths.
 Mark length with tape – length equals
device size minus desired door size (for
30" door = cut 6" off 36" device) ensuring
a square cut.
639400 Rev0 – 12/12/21
1. PREPARE DOOR
 Prepare door and frame according to
template.
 Refer to trim template if installing trim.
3. INSTALL DEVICE
 Install device and trim with 1/4-20 screws
from pack #639043.
 Device can be surface mounted to the
door, optional sex nuts are available,
device is through bolted if using trim.
Panic Fire Alarm MLR
36" Device 6" 8" 2" 3"
48" Device 12" 14" 8" 9"
Maximum cut off length:
Reinforced Steel
or Aluminum Door Surface Mount: Drill/Tap push side for 1/4-20
Solid Wood Door Drill 1/8" Pilot Hole for #10 Wood Screw
All Others Use optional Sex Bolts. Drill push side with
9/32" drill bit. Drill pull side with 3/8" drill bit.
Mounting Options:

2639400 Rev0 – 12/12/21
6300/6400R/RF EXIT INSTALLATION INSTRUCTION
RIM DEVICE
5. INSTALL HEAD COVER
 Slide head cover onto exit device
 Install 4 mounting screws
6. INSTALL STRIKE
 Install strike with roller toward door face
using two #10-24 pan head screws.
 Adjust strike to secure door.
 Install flat head locking screw by drilling
and tapping for #10-24 after final
adjustment is achieved.
4. INSTALL END CAP
 Slide end cap into rail. Ensure rail is level.
Mark the centers of the slots.
 Remove end cap then drill holes using the
chart from Step 3.
 Reinstall end cap and fasten with screws.