PE Wideband O2 User manual

QUICKSTARTGUIDE
PE Wideband O2 Kit P/N: 50070102-01
See other side for more information
WARNING
The PE Wideband O2 is intended for off-road use only. This
device is NOT waterproof. The sensor will get hot when
powered and MUST be connected to the powered O2 module
when installed in a running engine. Failure to do so will damage
the sensor. Fuels containing lead or 2-stroke oil will degrade
the sensor.
Performance Electronics, LTD assumes no responsibility for
any damage that results from incorrect installation or misuse of
this product. It is up to the end user to verify the correct setup
and determine the suitability for his or her specic application.
WARNING:
Cancer And Reproductive Harm
www.P65warnings.ca.gov
Part Identication
A
BC
DE
F
G
H
A. O2 Conditioning Module
B. CAN Input Pigtail
C. CAN Output Pigtail
D. Bosch LSU 4.9 Sensor
E. Mild Steel Weld In Bung
F. Mounting Holes
G. LED Status Indicator
H. Bluetooth Pairing Button

Scan QR
code for
more information
Document Number: 60000707-03pe-ltd.com • email: [email protected]
Calibration Points
Lambda = 0.14 x Vout =.58
Lambda at 0.0 (V)
Lambda at 0.5 (V)
Lambda at 4.5 (V)
Lambda at 5.0 (V)
0.58 λ
0.65 λ
1.21 λ
1.28 λ
Wiring the Conditioning Module
Wired Connection
Switched +12V
Ground
0-5V Output (optional)
Wire Color
Red (20ga)
Black (20ga)
Pink (20ga)
Pairing the O2 Module to a Smart Device
• Download the PE Wideband O2 app from the iOS App Store or Google Play
Store. Search for ‘PE Wideband’ or scan QR code below.
• Power the conditioning module by applying switched +12V to the red wire.
• Look for the indicator light to blink red rapidly, indicating the module has
power and the sensor is heating.
• Once the LED status indicator slows to a once-per-second blink pattern, open
the app and select NEXT. You should see the available sensor module Lambda
in the list.
• Press and hold the Bluetooth pairing button on the module until the indicator
light turns blue, then release.
• While the indicator light is ashing blue, select Lambda in the list.
• Once communication is established, the LED indicator will blink blue once per
second indicating the module is paired with the mobile device. The app will now
redirect to the main display screen.
MODULE STATUS AND ERRORS
LED Blink Pattern
Constant Red On
Constant Red On
Module Status App Message Description
Sensor Heating
Normal Operation
Bluetooth Pairing
Bluetooth Active
Device Identify
‘Heating’
--None--
--None--
--None--
--None--
During the first 20 seconds of operation, the sensor must heat up to function.
Normal operation with no errors. No active Bluetooth communication.
Module is ready to pair to a mobile device. This is initiated by holding the pair button.
Normal operation with no errors and active Bluetooth communication.
Rapid color sequence to identify the connected device. Initiated from the app.
Error
Error
‘Error’
‘Over Temp’
No sensor or bad sensor. Check the connection between the sensor and module.
The module itself is too hot. If hotter than 176°F (80°C), Bluetooth may stop functioning.