Perfect Aire 1PHC10 User manual

Perfect Aire, LLC
5401 Dansher Rd.
Countryside, IL 60525
Distributed by:
844-4PA-AIRE | 844-472-2473
www.perfectaire.us
CERAMIC
HEATER
FOR MODEL:
1PHC10
Before using your ceramic heater
please read this manual carefully and keep
it for future reference, along with your receipt.
Specification and performance data is subject to change without notice.
Printed in China
USER MANUAL
PA/User_1PHC10/05102019

1
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances,basic precautions should always be followed to
reduce the risk of fire,electric shock,and injury to persons,including the following:
1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surface. If provided, always use handles when moving this heater. Keep
combustible materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them away
from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Discard heater or
return heater to authorized service facility for examination, electrical or
mechanical adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathroom, laundry areas and similar moist
indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
9. This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of shock, this plug is intended to fit only one way in a
polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. DO NOT attempt to defeat this
safety feature. To do so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a
circuit, do not plug the heater into a circuit that already has other appliances
working.
11. It is normal for the plug to feel warm to the touch; however, a loose
fit between the AC outlet (receptacle) and plug may cause overheating and
distortion of the plug. Contact a qualified electrician to replace loose or worn
outlet.
CAUTION:
CAUTION:

2
12. To disconnect the heater, first turn controls to off, then remove plug from
outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surface, like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to
persons.
17. Always plug heaters directly into a wall outlet/receptacle. Never
use with an extension cord or reloadable power tap (outlet/power strip).
18. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
19. Disposal of oil contained within should be in accordance with applicable
regional, national, and local laws and regulations.
20. CAUTION: To prevent electric shock, match wide blade of plug to
wide slot and fully insert.
21.
OPERATING INSTRUCTIONS
“SAVE THESE INSTRUCTIONS”
Temperature
control knob
Pilot light
Power selection knob
Safty grill
Tip-over switch
Base enclosure
Handle
CAUTION:

3
OPERATING INSTRUCTION
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Put the machine on the flat place
Uneven place may possibly cause the turnover switch at abnormal position, then
the heater can’t work after turning on, therefore, please put the heater on the flat
place, at least the surface below the base of the heater must be flat.
Temperature Control Knob
Insert the plug into the power socket, then turn the Temperature Control knob
clockwise, when hearing the “poop” sound (it means the temperature controller is
on), adjust the Temperature Control knob to the desired temperature level.
Power Selection Knob
Turn the Power selection knob to select between 4 functions: Low 900W(LOW),
High 1500W(HIGH), Low 900W Swing (LOW SWING), High 1500W Swing (HIGH
SWING).
Turn off the Heater
A. Turn the Power selection knob to OFF position.
B. Turn the Temperature Control knob anticlockwise to the initial position.
C. Remove the power plug, store the heater after the entire machine has become
cool.
Safety Protection
1.Overheat protection: When the temperature in the heater is too high due to
abnormality in the use environment or improper use, the thermostat device can
automatically cut off the power and the heater stops working，then unplug the
heater. After the whole heater is cooling, plug the unit in again and operate
normally.
2.Inversion protection: When the whole heater is inverted, the safety system will
automatically cut off the power, and return to the work state before inversion after
the body is placed upright.
Tip-over switch
As a safety measure, the unit will shut off automatically if it is
knocked over. Should this occur, simply turn the heater off and stand it back up
to a regular upright posit ion, then switch it back on.

4
TROUBLESHOOTING
If the product does not operate or does not operate properly, first check according to the following
list. If the reason the product does not operate or does not operate properly is not included in the
following list, the product mayhave failed. At this time, it is recommended to send the product to
the dealer or the Media Service Center for treatment.
Problem Possible Cause Soluon
Aer the power is
engaged, the power
indicator light does not
illuminate and the
machine does not work.
The plug may not be
plugged well.
Check whether the plug is
properly inserted into the
receptacle.
The temperature control
knob is not turned in
place.
Check whether the
temperature control knob
is turned to the ON
posion.
The machine suddenly
stops during heang.
The temperature exceeds
the threshold of the
thermal cut-off.
Cool the machine before
use.
MAIN TECHNOLOGY SPECIFICATIONS
Power supply: AC 120V ~ 60Hz
MODEL LOW HIGH LOW OSC HIGH OSC
POWER REGULATION RANGE (W)
HT-1003 900 1500 900 1500
1PHC10

Perfect Aire, LLC
5401 Dansher Rd.
Countryside, IL 60525
Distributed by:
844-4PA-AIRE | 844-472-2473
www.perfectaire.us
CERAMIC
HEATER
FOR MODEL:
1PHC10
Before using your ceramic heater
please read this manual carefully and keep
it for future reference, along with your receipt.
Specification and performance data is subject to change without notice.
Printed in China
USER MANUAL
PA/User_1PHC10/05102019