Philips NE5512 Owner's manual

Philips Semiconductors Linear Products Product specification
NE/SA/SE5512Dual high-performance operational amplifier
78
August 31, 1994 853-0948 13721
DESCRIPTION
The 5512 series of high-performance operational amplifiers provides
very good input characteristics. These amplifiers feature low input
bias and voltage characteristics such as a 108 op amp with
improved CMRR and a high differential input voltage limit achieved
through the use of a bias cancellation and PNP input circuits with
collector-to-emitter clamping. The output characteristics are like
those of a 741 op amp with improved slew rate and drive capability,
yet have low supply quiescent current.
APPLICATIONS
•AC amplifiers
•RC active filters
•Transducer amplifiers
•DC gain block
•Battery operation
•Instrumentation amplifiers
FEATURES
•Low input bias < ±20nA
•Low input offset current < ±20nA
•Low input offset voltage <1mV
•Low VOS temperature drift 5µV/°C
•Low input bias temperature drift 40pA/°C
•Low input voltage noise 30nV/√Hz
•Low supply current 1.5mA/amp
•High slew rate 1.0V/µs
•High CMRR 100dB
PIN CONFIGURATIONS
N Package
D Package1
NOTE:
1.The D package pinout is not functionally identical
to the N pinout.
8
7
6
54
3
2
1OUTPUT 1
-INPUT 1
+INPUT 1
V-
V+
OUTPUT 2
-INPUT 2
+INPUT 2
8
7
6
54
3
2
1+ INPUT 1
-INPUT 2
+INPUT 2
V-
V+
OUTPUT 1
-INPUT 1
OUTPUT 2
TOP VIEW
TOP VIEW
1
2
•High input impedance 100MΩ
•High PSRR 110dB
•High differential input voltage limit
•No crossover distortion
•Indefinite output short circuit protection
•Internally-compensated for unity gain
•600Ωdrive capability
•MIL-STD processing available
ORDERING INFORMATION
DESCRIPTION TEMPERATURE RANGE ORDER CODE DWG #
8-Pin Plastic Small Outline (SO) Package 0 to 70°C NE5512D 0174C
8-Pin Plastic Dual In-Line Package (DIP) 0 to 70°C NE5512N 0404B
8-Pin Plastic Small Outline (SO) Package -40 to +85°C SA5512D 0174C
8-Pin Plastic Dual In-Line Package (DIP) -40 to +85°C SA5512N 0404B
8-Pin Plastic Dual In-Line Package (DIP) -55 to +125°C SE5512N 0404B

Philips Semiconductors Linear Products Product specification
NE/SA/SE5512Dual high-performance operational amplifier
August 31, 1994 79
ABSOLUTE MAXIMUM RATINGS
SYMBOL PARAMETER RATING UNIT
VCC Supply voltage ±16 V
PDMAX Maximum power dissipation,
TA=25°C (still air)1
N package 1212 mW
D package 800 mW
TAOperating ambient temperature range
NE5512 0 to +70 °C
SA5512 -40 to +85 °C
SE5512 -55 to +125 °C
TSTG Storage temperature range -65 to +150 °C
TSOLD Lead soldering temperature (10sec max) 300 °C
NOTES:
1. The following derating factors should be applied above 25°C
N package at 9.7mW/°C
D package at 6.4mW/°C

Philips Semiconductors Linear Products Product specification
NE/SA/SE5512Dual high-performance operational amplifier
August 31, 1994 80
ELECTRICAL PERFORMANCE CHARACTERISTICS
VCC = ±15V, TA= 25°C over temperature range, unless otherwise specified.
SYMBOL
PARAMETER
TEST CONDITIONS
SE5512 NE/SA5512
UNIT
SYMBOL
PARAMETER
TEST CONDITIONS
Min Typ Max Min Typ Max
UNIT
VOS Input offset voltage RS=100Ω
TA=+25°C
Over temp. 0.7 12 31 1.5 5 6mV
∆VOS/∆T 4 5 µV/°C
IOS Input offset current RS=100kΩ
TA=+25°C
Over temp. 3 410 20 6 820 30 nA
∆IOS/∆T 30 40 pA/°C
IBIAS Input bias current RS=100kΩ
TA=+25°C
Over temp. 3 410 20 6 820 30 nA
∆IBIAS/∆T 30 40 pA/°C
RIN Input resistance differential TA=+25°C 100 100 MΩ
VCM Input common mode range TA=+25°C
Over temp. ±13.5 ±13 ±13.7 ±13.2 ±13.5 ±13 ±13.7 ±13.2 V
CMRR
Input common-mode rejection
ratio
VCC=±15V
VIN=±13.5V
CMRR
Input common-mode rejection
ratio
TA=+25°C 70 100 70 100 dB
ratio
VIN=±13V
Over temp.
AVLarge-signal voltage gain RL=2kΩTA=25°C
VO=±10V over temp. 50
25 200 50 25 200 V/mV
SR Slew rate TA=25°C 0.6 1 1 V/µs
GBW Small-signal unity gain band-
width TA=25°C 3 3 MHz
θMPhase margin TA=25°C 45 45 degree
VOUT Output voltage swing RL=2kΩ
TA=25°C
Over temp. ±13 ±12.5 ±13.5 ±13 ±13 ±12.5 ±13.5 ±13 V
VOUT Output voltage swing RL=600Ω1 TA=25°C
Over temp. ±10 ±7.5 ±11.5 ±9±10 ±8±11.5 ±9V
ICC Power supply current RL=Open
TA=25°C
Over temp. 3.4 3.6 5 5.5 3.4 3.6 5 5.5 mA
PSRR Power supply rejection ratio Over temp. 80 100 80 100 dB
AA Amplifier-to-amplifier coupling f=1kHz to 20kHz,
TA=25°C -120 -120 dB
THD Total harmonic distortion f=10kHz
TA=25°C
VO=7VRMS
0.01 0.01 %
VNOISE Input noise voltage f=1kHz
TA=25°C30 30 nV/√Hz
INOISE Input noise current f=1kHz
TA=25°C0.2 0.2 pA/√Hz
ISC Short-circuit current ±15V, TA=25°C 40 40 mA
NOTES:
1. Not to exceed maximum package power dissipation.

Philips Semiconductors Linear Products Product specification
NE/SA/SE5512Dual high-performance operational amplifier
August 31, 1994 81
EQUIVALENT SCHEMATIC
V+
OUTPUT
-V
-VIN
(ONE OP AMP)
+VIN