Philips AJ3112/96 User manual

Clock Radio
Register your product and get support at
www.philips.com/welcome
User manual
AJ3112

3
4
1
#%^ $
5
9
0
678
2
!
@

English
CONTROLS (see fig. 1)
1
DISPLAY - shows the clock/ alarm time and status of the set
2ALARM indicator -
lights up when alarm is activated
3Frequency indicator
- shows the radio frequency of your selected waveband
4REPEAT ALARM / SLEEP OFF
- switches off the active alarm for a 8-9 minute period
- switches off the sleep function
5CLOCK - sets the clock time
6SLEEP
- activates the radio for sleep function
- adjusts the sleep period
7
ALARM RESET - stops the active alarm for 24 hours
8
ALARM - sets the alarm function
9
RADIO / ALARM
RADIO ON: switches on the radio
RADIO OFF: switches off the radio/alarm
ALARM - RADIO: activates the radio for alarm
ALARM - BUZZ: activates the buzzer for alarm
0
SET TIME HR / MIN
- adjusts the hours / minutes for clock / alarm / sleep time
!Power cord -
connects to wall outlet
@Pigtail - improve FM reception
#VOLUME - adjusts the sound level
Congratulations on your purchase and welcome to
Philips!
To fully benefit from the support that Philips offers,
register your product at www.philips.com/welcome.

$
Battery door - opens to store a 9 volts 6F22 battery (not included)
for clock memory backup.
%
FM/MW - selects FM/MW waveband
^TUNING - tunes to radio stations
INSTALLATION
POWER SUPPLY
1
Check if the power supply, as shown on the type plate located
on the bottom of the set, corresponds to your local power sup-
ply. If it does not, consult your dealer or service center.
2 Connect the plug to the wall outlet.
3 To disconnect the set from the power supply completely,
remove the plug from the wall outlet.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to
be stored for up to a day when there is a power interruption e.g. power
failure.The complete clock radio and display illumination will be switched
off. As soon as the power supply returns, the display will indicate the cor-
rect time.
1 Remove the battery door to insert a 9 volts 6F22 type battery (not
included) for backup.
2 Replace the battery door.
NOTE: If no backup battery is installed or the power interruption is pro-
longed, you will need to set the clock and alarm times again.
Batteries contain chemical substances so they should be dis-
posed of properly.

RADIO
You can use this set solely as a radio!
1
Adjust RADIO / ALARM to RADIO ON to switch on the radio.
2 Select your waveband by adjusting the FM/MW switch .
3
Adjust TUNING to tune to your desired station .
4
Turn the VOLUME control to adjust the volume level .
5
Adjust RADIO / ALARM to OFF to switch off the radio.
To improve reception:
FM: Extend and position the pigtail fully to obtain optimal
reception.
MW: uses a built-in antenna inside the set. Direct the antenna
by adjusting the position of your set
.
To improve reception:
FM: Extend and position the pigtail fully to obtain optimal
reception.
MW: uses a built-in antenna inside the set. Direct the antenna
by adjusting the position of your set
.
SETTING THE CLOCK / ALARM TIME
The time is displayed using the 24-hour clock.
1 Hold down CLOCK or ALARM.
2 Press HR or MIN repeatedly, or hold down HR or MIN to adjust
minute and/or hour.
3 Release CLOCK or ALARM and HR or MIN when you reach
the correct setting.
™
The set clock time will show on the display and start to run.

SELECTING THE ALARM MODE
To use the alarm, you must set the alarm time first.You can choose
from two different alarm modes to wake you up: by radio or buzzer.
1 Select your choice of alarm mode by adjusting RADIO / ALARM
to RADIO or BUZZ .
™
The alarm indicator (AL) will light up.
Helpful Hint:
• If you have selected the radio mode, make sure you have adjusted
the volume loud enough to wake you.
• The buzzer is set at a fixed volume and cannot be adjusted.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24 hour alarm reset option will be automatically selected
after 1 hour and 59 minutes, from the time your alarm time first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish
to retain the same alarm setting for the following day:
• Press ALARM RESET during the alarm call.
™
The alarm indicator (AL) will remain on.
CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the alarm call:
• Adjust RADIO / ALARM to OFF position.
™
The alarm indicator (AL) will light off.
REPEAT ALARM
This repeats your alarm call at 9-minute intervals.
1 During the alarm call, press REPEAT ALARM /
SLEEP OFF
.
™
The alarm indicator (AL) will remain on.

SLEEP
This set has a built-in timer which enables the set to be automatically
switched off during radio playback after a set period of time.This allows
you to lie back, listen and fall asleep.The maximum sleep time is 1 hour
and 59 minutes.
Setting SLEEP
1 Set RADIO / ALARM to OFF position.
2 Set the sleep time to activate sleep function by selecting on the fol-
lowing ways:
• Simply press SLEEP to set your sleep time to 59 minutes.
• Hold down SLEEP , and press MIN repeatedly to adjust sleep time
from 59 minutes downward.
• Hold down SLEEP and press HR to get one more hour sleep time
(1:59)
™
To cancel sleep, press REPEAT ALARM /
SLEEP OFF
.

SAFETY INFORMATION
•
Install the unit near the AC outlet and where the AC plug can be
easily reached.
• Where the MAINS plug is used as the disconnect device, the dis-
connet device shall remain readily operable.
• Place the set on a hard and flat surface so that the system does not tilt.
• If you do not intend to use the set for a long time, withdraw the
power plug from the wall outlet. In addition to this, it is advisable to
remove the battery from the clock radio.This will prevent any dan-
ger of leakage and the clock radio will not be damaged.
• Do not expose the set, batteries to humidity, rain, sand or excessive
heat caused by heating equipment or direct sunlight.
• The apparatus shall not be exposed to dripping or splashing.
• Adequate ventilation with a minimum gap of 15cm between the ven-
tilation holes and surrounding surfaces is necessary to prevent heat
build-up.
• The ventilation should not be impeded by covering the ventilation
openings with items, such as newspapers, table-cloths, curtains, etc..
• No objects filled with liquids, such as vases, shall be placed on the appartus.
• No naked flame sources, such as lighted candles, should be placed
on the apparatus.
• To clean the set, use a soft, slightly dampened chamois leather. Do
not use any cleaning agents containing alcohol, ammonia, benzene
or abrasives as these may harm the housing.
• Battery shall not be exposed to excessive heat such as sunshine, fire
or the like.
CAUTION
Use of controls or adjustments or performance of proce-
dures other than herein may result in unsafe operation.

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your
dealer or service center.
WARNING: Under no circumstances should you try to repair the set your-
self, as this will invalidate the warranty. Do not open the set as
there is a risk of electric shock.
Problem
– Possible Cause
• Remedy
No sound/power
– Volume not adjusted
• Adjustthevolume
Occasional crackling sound during FM broadcast
– Weak signal
•
Adjust the position of the Pigtail
Continuous crackling/hiss disturbance during MW broadcast
– Electrical interference from TV, computer, fluorescent lamp, etc.
• Movesetawayfromotherelectricalequipment
The alarm does not function
– Alarm time not set and or alarm mode not selected
• Set the alarm time and / select alarm mode
– Volume too low for RADIO
• Adjustthevolume
–
Radio alarm not adjusted to radio station
• Tunetoaradiostation

Notes for battery disposal
Your product contains batteries covered by the European Directive 2006/66/
EC, which cannot be disposed with normal household waste. Please inform
yourself about the local rules on separate collection of batteries because cor-
rect disposal helps to prevent negative consequences for the environmental
and human health.
Environmental information
We have reduced packaging to the minimum for easy separation into
two materials: paper and cardboard. Your set consists of materials which
can be recycled if disassembled by a specialized company. Please observe
local regulations on the disposal of packing materials and old equipment.
Disposal of your old product
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.When this crossed-
out wheeled bin symbol is attached to a product it means the product is
covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for
electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste.The correct disposal of your
old product will help prevent potential negative consequences for the
environment and human health.