Philips AJ1000/93 User manual

Register your product and get support at
AJ1000
EN User manual

1 Important
Safety
aRead these instructions.
bKeep these instructions.
cHeed all warnings.
dFollow all instructions.
eDo not use this apparatus near water.
fClean only with dry cloth.
gDo not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
hDo not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including ampliers)
that produce heat.
iProtect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
j Only use attachments/accessories specied by the
manufacturer.
kUnplug this apparatus during lightning storms or when
unused for long periods of time.

l Refer all servicing to qualied service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
mApparatus shall not be exposed to dripping or splashing.
nDo not place any sources of danger on the apparatus (e.g.
liquid lled objects, lighted candles).
oWhere the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.
Warning
Never remove the casing of this apparatus.•
Never lubricate any part of this apparatus.•
Never place this apparatus on other electrical equipment.•
Keep this apparatus away from direct sunlight, naked ames or heat. •
Never look into the laser beam inside this apparatus.•
Ensure that you always have easy access to the power cord, plug or•
adaptor to disconnect this apparatus from the power.
Notice
Any changes or modications made to this device that are not
expressly approved by Philips Consumer Lifestyle may void the
user’s authority to operate the equipment.

Recycling
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products. The correct disposal of your old
product helps prevent potentially negative consequences on the
environment and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried
to make the packaging easy to separate into three materials:
cardboard (box), polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can be recycled and
reused if disassembled by a specialized company. Please observe
the local regulations regarding the disposal of packaging materials,
exhausted batteries and old equipment.

2 Your clock radio
Congratulations on your purchase, and welcome to Philips!To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
Introduction
With this clock radio, you can:
enjoy the FM radio•
know the time•
wake up to buzz or favorite radio tone•
set two alarms to ring at different time.•
What’s in the box
Check and identify the contents of your package:
Main unit (with power adapter attached)•
User manual•
Quick start guide•

a
f
c
d
e
b
g
i
j
d
k
l
e
h
100

Overview of the main unit
aTUNING
Tune to a radio station.•
bREPEAT ALARM/SLEEP OFF
Repeat the alarm.•
Disable the sleep timer.•
cSLEEP
Set the sleep timer.•
d/
Adjust the times of clock, alarm timer and sleep timer.•
eAL1, AL2
• RADIO: Set the current radio station as alarm tone.
• BUZ: Set buzz as alarm tone.
• OFF: Turn off the alarm timer.
fVOL
Adjust the volume level of radio.•
gDisplay panel
hAL RESET
Stop the alarm.•
iRADIO ON/OFF
Turn on or off radio.•
jBRIGHTNESS CONTROL
Adjust the brightness of display panel.•

kClock Control
• SET TIME: Activate the clock time setup.
• SET AL1/AL2: Activate the alarm time setup; display
the set alarm time.
• CLOCK: Display the clock time.
lFM ANT
Attached FM radio antenna.•

3 Get started
Caution
Use of controls or adjustments or performance of procedures•
other than herein may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial
number of this apparatus.The model number and serial number are
on the bottom of the apparatus.Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect power
Caution
Risk of product damage! Ensure that the power supply voltage•
corresponds to the voltage printed on the back or the underside of
the apparatus.
Risk of electric shock! When you unplug the AC power cord, always
•
pull the plug from the socket. Never pull the cord.
Before connecting the AC power cord, ensure you have completed
•
all other connections.
1Connect the power adapter to the power socket.

Set the clock time
1Switch Clock Control to SET TIME.
2Press / to set the time (24-hour system).
3Switch Clock Control to CLOCK.
Tip
Press and hold•to fast increase the time digits.
Press
•to decrease the time digits one by one.

4 Listen to radio
Tune to a radio station
1Press RADIO ON/OFF to turn on the radio.
2Adjust TUNING slowly to tune to a radio station.
To turn off the radio, press• RADIO ON/OFF again.
Adjust the volume level
1Rotate VOL clockwise or anti-clockwise.

5 Set the alarm timer
Set the alarm time
You can set two separate alarms. For the alarm tone, you can select
the buzz or the FM radio.
Note
Before you start, ensure that the time is set correctly.•
1Switch Clock Control to AL1 or AL2 (on SET AL1/AL2).
2Press / to set the alarm time.
3Switch Clock Control to CLOCK.
Turn on the alarm timer
Note
Ensure the alarm time is set successfully.•
1Switch AL1/AL2 to BUZ or RADIO.
»/ appears.
The buzz or FM radio is set for alarm tone.»
View the alarm time
1Switch Clock Control to AL1 or AL2 (on SET AL1/AL2).
»or appears.
The preset alarm time is displayed.»

Repeat alarm
1When the alarm rings, press REPEAT ALARM/SLEEP OFF.
The alarm repeats ringing 7 minutes later.»
Stop alarm ring
1When the alarm rings, press AL RESET.
The alarm stops but the alarm settings remain.»
Turn off the alarm timer
1Switch AL1/AL2 to OFF.
»/ disappears.
6 Other features
Set the sleep timer
You can set the clock radio to turn off automatically after a certain
period of time (0 to 59 minutes).
Note
Before the setup, ensure•Clock Control is switched to CLOCK and
the radio is turned off.
1Press and hold SLEEP.
The time digits count down from»0:59 to 0:00.
The radio turns on.»
2Press / repeatedly to adjust the time.

3Release SLEEP when the desired time digits are displayed.
To turn off the sleep timer:
1Press REPEAT ALARM/SLEEP OFF.
Adjust display brightness
1Switch BRIGHTNESS CONTROL to HI or LO.
• HI: For high brightness level
• LO: For low brightness level

7 Product information
Note
Product information is subject to change without prior notice.•
Specications
Tuner (FM)
Tuning Range 87.5 - 108 MHz
Sensitivity
- Mono, 26dB S/N Ratio
< 22 dBf
Total Harmonic Distortion < 3%
Signal to Noise Ratio > 50 dB
General information
AC Power Input: 220 V~ ,50Hz
Operation Power Consumption 3 W
Dimensions
- Main Unit (W x H x D) 185 x 52 x 85 mm
Weight
- Main Unit 0.4 kg

8 Troubleshooting
Caution
Never remove the casing of this apparatus.•
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support).When
you contact Philips, ensure that your apparatus is nearby and the
model number and serial number are available.
No power
Ensure that the Mains cord is connected securely.•
Ensure that there is power at the AC Mains.•
No sound
Adjust the volume.•
No response from the unit
Disconnect and reconnect the AC power plug, then turn on•
the unit again.
Poor radio reception
Increase the distance between the apparatus and your TV•
or VCR.
Fully extend the antenna.•
Connect an outdoor antenna instead.•
Timer does not work
Set the clock correctly.•
Switch on the timer.•

Clock/timer setting erased
Power has been interrupted or the power plug has been•
disconnected.
Reset the clock/timer.•

© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ1000_93_UM_V1.0