Philips AJ3115 User manual

b
ac
d
15 30 60 90 120
OFF
SLEEP
HR
MIN
PRESET/
SET TIME
1 2
3 4
2 sec
PRESET/
SET TIME
e
2 sec
HR
TUNING
RADIO
ON/OFF
2 sec
1 2
3 4
f
MIN
TUNING
VOLUME
VOLUME
2 sec
1 2
g
HR
MIN
3 4
h
AL1FM
AL 1
Register your product and get support at
www.philips.com/support AJ3115
User manual
This product has been manufactured by, and is sold
under the responsibility of Gibson Innovations Ltd.,
and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
AJ3115_94_UM_V1.0

EN
1 Important
• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including ampliers) that produce heat.
• Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point where
they exit from the clock radio.
• Only use attachments/accessories specied by the manufacturer.
• Unplug this clock radio during lightning storms or when unused for
long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required
when the clock radio has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the clock radio, the clock radio has been exposed to
rain or moisture, does not operate normally, or has been dropped.
• Battery usage CAUTION –To prevent battery leakage which may
result in bodily injury, property damage, or damage to the clock radio:
• Install the battery correctly, + and - as marked on the clock radio.
• Remove the battery when the clock radio is not used for a long
time.
• The battery shall not be exposed to excessive heat such as
sunshine, re or the like.
• This clock radio shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the clock radio (e.g. liquid
lled objects, lighted candles).
• Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
operable.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/support.
What’s in the box (Fig. )
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery
You can only use AC power as power supply.The battery can only back
up clock and alarm settings.
Caution
• Risk of explosion! Keep the battery away from heat, sunshine or re.
Never discard battery in re.
• The battery contains chemical substances, so it should be disposed of
properly.
Insert 2 AAA batteries (not supplied) with correct polarity (+/-).
(Fig. )
Tip
• The display backlight is off when AC power is disconnected.
Connect power (Fig. )
Caution
• Risk of product damage! Make sure that the power voltage corresponds
to the voltage printed on the back or underside of the clock radio.
• Risk of electric shock! When you unplug the power adapter, always pull
the plug from the socket. Never pull the cord.
Note
• The type plate is located at the bottom of the clock radio.
Set time (Fig. )
Note
• You can only set time in standby mode.
4 Listen to FM radio
Note
• Keep the clock radio away from other electronic devices to avoid radio
interference.
• For better reception, fully extend and adjust the position of the FM antenna.
Tune to FM radio stations (Fig. )
Store FM radio stations manually
You can store up to 10 FM radio stations.
1 Tune to an FM radio station.
2 Press and hold PRESET for two seconds.
» The preset number begins to blink.
3 Press TUNING repeatedly to select a number.
4 Press PRESET again to conrm.
5 Repeat steps 1 to 4 to store other stations.
Tip
• To remove a pre-stored station, store another station in its place.
Select a preset radio station
In tuner mode, press PRESET repeatedly to select a preset number.
Adjust volume
While listening, press - VOLUME + to adjust volume.
5 Other features
Set alarm timer
You can set two alarms to ring at different time.
Set alarm
Note
• You can only set the alarm in standby mode.
• Make sure that you have set the clock correctly.
Follow the illustration to set the rst alarm. (Fig. )
• AL1: set the rst alarm.
• AL2: set the second alarm.
Tip
• The clock radio exits alarm setting mode when being idle for 10
seconds.
Select alarm source
You can select FM radio or buzzer as the alarm source. (Fig. )
» The corresponding alarm icon lights up.
Note
• If FM radio is selected as alarm source, when alarm sounds, volume rises
gradually.You cannot adjust the alarm volume manually.
• If Buzzer is selected as alarm source, the alarm volume will be at default level
and cannot be adjusted.
Activate/deactivate the alarm timer
Press AL1 or AL2 repeatedly to activate or deactivate the alarm timer.
(Fig. )
» If the alarm timer is deactivated, the alarm indicator turns off.
» The alarm repeats ringing for the next day.
Snooze the alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing nine minutes later.
Set sleep timer
This clock radio can switch to standby mode automatically after a preset
period. (Fig. )
To deactivate the sleep timer:
• Press SLEEP repeatedly until [OFF] (off) appears.
6 Product information
Note
• Product information is subject to change without prior notice.
Specications
Amplier
Total Output Power 200 MW RMS
Tuner (FM)
Tuning range 87.5-108 MHz
Tuning grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
- Stereo, 46 dB S/N Ratio
<22 dBf
<51.5 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC power (power adapter) Brand name: Philips;
Model: YLS0041A-I050055;
Input: 100-240 V ~, 50/60 Hz; 0.3 A;
Output: 5 V 0.55 A
Operation Power Consumption 5 W
Standby Power Consumption <1 W
Dimensions:
Main Unit (W x H x D) 130 x 46 x 130 mm
Weight:
-Main Unit
-With Packing
0.26 kg
0.3 kg
7 Troubleshooting
Warning
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support). When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
•Ensure that the AC power adaptor of the unit is connected properly.
•Ensure that there is power at the AC outlet.
No sound
•Adjust the volume.
No response from the unit
•Disconnect and reconnect the AC power plug, then turn on the unit
again.
Poor radio reception
•Increase the distance between the unit and your TV or VCR.
•Fully extend the FM antenna.
Alarm does not work
•Set the clock/alarm correctly.
Clock/alarm setting erased
•Power has been interrupted or the power plug has been
disconnected.
•Reset the clock/alarm.
8 Notice
Any changes or modications made to this device that are not expressly
approved by Gibson Innovations may void the user’s authority to
operate the equipment.
This product complies with the radio interference
requirements of the European Community.
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a
product it means that the product is covered by the European
Directive 2002/96/EC.
Please inform yourself about the local separate collection
system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Your product contains batteries covered by the European
Directive 2006/66/EC, which cannot be disposed with normal
household waste.Please inform yourself about the local rules
on separate collection of batteries because correct disposal helps to
prevent negative consequences for the environmental and human
health.
Environmental information
All unnecessary packaging has been omitted.We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.