8
BWarning:
Keep away from the steam vent during
brewing, as hot steam escapes through the
vent.
•The grinder grinds the required amount of
coffee beans.
•The freshness indicator ashes rapidly on
the display until the brewing process is
nished.
•The coffeemaker beeps 5 times when the
brewing process is nished.
12 Wait until the coffeemaker has stopped
beeping before you remove the thermos jug.
DNote:
basket for several seconds.
•The freshness indicator ashes slowly on
the display for 30 minutes after brewing,
to indicate that the coffee is fresh. (Fig. 20)
13 To pour out coffee, turn the lid to the ‘pour’
position. In this position, the arrowhead on
the lid points to the ‘pour’ symbol on the
rim (Fig. 21).
DNote:
To keep the coffee hot, always close the lid
after pouring out.
5.3 Using pre-ground coffee
If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
1 Follow steps 1 and 2 in section ‘Using coffee
beans’.
2
DNote:
How much pre-ground coffee you use is a
matter of personal taste. For a medium-strong
cup of coffee, use one measuring spoon
(approximately 6g) for each cup (125ml).
3
4 Turn the lid of the thermos jug by its lever to
the ‘closed/brewing’ symbol on the lid. Put the
thermos jug in the appliance.
BWarning:
The maximum capacity of the coffee bean
container is 250g. To prevent the grinder
from jamming, do not exceed this amount.
BWarning:
To prevent the grinder from jamming, do not
use unroasted or caramelised beans.
7 Turn the grind selection knob to select the
There are nine grind settings (Fig. 15).
ETip:
We advise you to experiment with the
setting you prefer.
8 To select the number of cups, press the
4-10 cups button as many times as the
desired number of cups (Fig. 16).
•When you press the 4-10 cups button, it
lights up briey and the appliance beeps.
•The selected number of cups appears on
the display.
DNote:
Make sure that the number of cups you select
with the 4-10 cups button is consistent with
the amount of water in the water reservoir.
Please keep in mind that the coffeemaker
uses all the water in the water reservoir. If you
select a number of cups that is smaller than
the amount of water, the coffee becomes
weaker than you intended.
9 Press the STRENGTH button once or several
times until the desired coffee strength is
selected (mild, medium or strong) (Fig. 17).
•When you press the STRENGTH button,
it lights up briey and the appliance beeps.
•The display shows the selected coffee
strength.
10 Press the start/standby button (Fig. 18).
•The appliance beeps and the display lights up.
11 Press the start/standby button again to start
the brewing process (Fig. 19).
4222_200_0561_4_DFU-Redeisgn_A5_v2.indd 8 1/23/13 12:24 PM