Philips sonicare AirFloss Ultra User manual

AirFloss Ultra

1

Philips Sonicare AirFloss Ultra
ENGLISH 6
FRANÇAIS 14
28
35

6
Introduction
Congratulations on your purchase and welcome to Philips! To fully benet
from the support that Philips offers, register your appliance at
www.philips.com/welcome.
Use AirFloss Ultra with your favorite mouthwash as part of your oral care
routine. In addition to brushing, AirFloss Ultra helps reduce the plaque in
between teeth in order to improve your gum health.
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Danger
- Keep the charger away from water. Do not place or store it over or
near water contained in a bathtub, washbasin, etc. Do not immerse
the charger in water or any other liquid. After cleaning, make sure
the charger is completely dry before you connect it to the mains.
Warning
- The mains cord cannot be replaced. If the mains cord is damaged,
discard the charger. Always have the charger replaced with one of
the original type in order to avoid a hazard.
- Use only charger type HX6100 provided with the AirFloss Ultra to
recharge the battery.
- If the appliance is damaged in any way (AirFloss Ultra nozzle,
handle and/or charger), stop using it.
- This appliance contains no serviceable parts. If the appliance is
damaged, contact the Consumer Care Centre in your country
(see chapter ‘Guarantee and support’).
- Do not use the charger outdoors or near heated surfaces.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
ENGLISH

Caution
- Consult your dentist before you use this appliance if you have had
recent oral or gum surgery, suffer from an ongoing dental condition,
had extensive dental work in the previous 2 months, or have
suspected issues with your dental work (lings, crowns, etc.).
- Consult your dentist if excessive bleeding occurs after using this
appliance or if bleeding continues to occur after 4 weeks of use.
- If you have medical concerns, consult your doctor before you use
this appliance.
- This Philips appliance complies with the safety standards for
electromagnetic devices. If you have a pacemaker or other implanted
device, contact your physician or the appliance manufacturer of
the implanted appliance prior to use.
- Do not use attachments other than the ones recommended by
the manufacturer.
- Do not exert excessive pressure on the nozzle tip of the nozzle.
- To avoid physical injury, do not ll the reservoir with hot water.
Do not put foreign objects in the reservoir.
- Only use the AirFloss Ultra for its intended purpose as described in
this user manual.
- To avoid physical injury, do not direct the spray under the tongue or
into the ear, nose, eye or other sensitive area.
- Do not clean the AirFloss Ultra nozzle, the handle, the charger,
the water reservoir and its cover in the dishwasher or a microwave.
- To avoid an ingestion hazard, do not put isopropyl alcohol or other
cleaning uids in the reservoir.
- The AirFloss Ultra is a personal care appliance and is not intended for
use on multiple patients in a dental practice or institution.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic elds.
ENGLISH 7

General description (Fig. 1)
1 Nozzle tip
2 AirFloss Ultra nozzle
3 Activation button
4 Reservoir and reservoir cover
5 Handle
6 Charge & burst mode indicators
- Single burst: 1 LED
- Double burst: 2 LEDs
- Triple burst: 3 LEDs
7 Power/mode button
8 Removable nozzle holder (select models)
9 Charger
Note:The contents of the box may vary based on the model purchased.
Charging
Charge the AirFloss Ultra for 24 hours before rst use.
1 Put the plug of the charger in the electrical outlet.
2 Place the handle on the charger (Fig. 2).
,Charging process: (Fig. 3)
- 1 green LED: 33% charged.
- 2 green LEDs: 66% charged.
- 3 green LEDS: 100% charged.
Note:When it is fully charged,AirFloss Ultra has an operating time of up to
11 days when it is used in triple burst mode, and up to 33 days when it is
used in single burst mode.
Note: When the charge indicators ash yellow, the battery is low and needs to
be recharged (fewer than 3 uses left).
ENGLISH8

Preparing for use
1 Align the nozzle and press the nozzle down onto the handle
(‘click’) (Fig. 4).
Note:We advise you to place the tip facing the front of the handle as
the illustration shows, but the nozzle can be placed in the handle either way
without affecting the function.You can try both options and use what works
best for you in your oral care routine.
Note: Replace the nozzle (HX8032, HX8033) every 6 months for optimal
results.Also replace the nozzle if it becomes loose or no longer ‘clicks’ onto
the handle.
Note:The AirFloss Ultra only supports AirFloss Ultra nozzles. Do not attempt
to use non-AirFloss Ultra nozzles on the AirFloss Ultra handle.
2 Open the cover of the reservoir (‘click’) (Fig. 5).
3 Fill the reservoir with mouthwash or water (Fig. 6).
Tip: For the best result and a fresher experience, we advise you to use
mouthwash with your AirFloss Ultra.
Note: Do not use mouthwash that contains isopropyl myristate
(e.g. Dentyl Active) or high concentrations of essential oils, as it may damage
the appliance.This includes all mouthwash sold in glass and ceramic
packaging.
4 Close the cover of the reservoir by pressing (‘click’) (Fig. 7).
5 Press the power/mode button to switch on the appliance. (Fig. 8)
,The LEDs illuminate.
6 Press and hold the activation button until spray comes out of
the tip of the nozzle (Fig. 9).
ENGLISH 9

Using the appliance
1 Make sure the AirFloss Ultra is switched on. If it is off, press and
release the power/mode button to switch on the appliance. (Fig. 8)
,You can change the modes to have the desired amounts of bursts
each time you press the activation button. For optimal results, use
the triple burst mode (the default setting) from both the outside
and inside of your teeth.
,To change modes, press the power/mode button to cycle through
the modes until you reach your desired mode.The LEDs show
the selected mode:
- Single burst: 1 LED (Fig. 10)
- Double burst: 2 LEDs (Fig. 11)
- Triple burst: 3 LEDs (Fig. 12)
Note:The AirFloss Ultra remembers what mode was selected last and it is
ready for the next use. If your AirFloss Ultra becomes fully drained of power,
it will go back to the triple burst default mode once it has been recharged.
2 Place the nozzle tip between two teeth at your gum line.
Slightly close your lips over the nozzle when it is in place,
to avoid splashing (Fig. 13).
3 Press the activation button to deliver 1-3 bursts (depending on
the selected mode) of air and micro-droplets of mouthwash or
water between the teeth. (Fig. 14)
4 Slide the nozzle tip along the gum line until you feel it settle
between the next two teeth.
5 Continue this procedure for all spaces between your teeth,
including behind your back teeth (Fig. 15).
Note: Rell the reservoir as needed.
ENGLISH10