Philips SHB6000 User manual

Welcome to Philips!
For an optimal experience, register your product at
www.philips.com/welcome.
© 2010 Koninklijke Philips Electronics N.V. All rights reserved.
Trademarks are the property of Koninklijke Philips
Electronics N.V. or their respective owners.
V1.0
Exchangeable ear caps
Power on/off
Mic
LED
Adjustable ear hook
Charging socket
EN Quick Start Guide
Philips Bluetooth stereo headset SHB6000
The red/blue LED flashes alternately. The headset is ready for pairing.
The blue LED flashes once every 6 seconds. The headset is connected to the device.
The blue LED flashes twice every 3 seconds. The headset is not connected.
The blue LED flashes once every half a second. There is an incoming/outgoing call.
The blue LED flashes once every second. The headset is active on a call.
The red LED flashes three times and
beeps twice every minute.
The battery is low in power.
Solid red LED. The headset is charging.
The LED is off. The headset is off./Charging is finished.
The headset beeps every 5 seconds. The Mic is muted.
LED and sound indication
SHB6000_QSG_EN.indd 1-3SHB6000_QSG_EN.indd 1-3 2010-8-2 10:59:572010-8-2 10:59:57

Turn headset on/off Hold until LED turns on/off.
Play / Pause music Tap
Stop music Hold
Next / Previous track Tap /
Adjust volume Press VOL +/VOL -
Pick up / End a call Tap
Reject a call Hold
Redial the last number Press twice quickly.
Activate voice dialing* Hold until beep occurs.
Mute/Unmute the Mic Double tap during a call.
Transfer a call to a mobile phone Hold during a call.
Operate the headset
Please refer to www.philips.com/welcome for full user manual.
Pair the headset with your mobile phone
1Ensure that the mobile phone is
turned on and its Bluetooth feature
is activated.
2Ensure that the headset is charged
and turned off.
3Press until the LED starts flashing
red and blue alternately. Do not
stop pressing the button after see-
ing the blue LED only.
The headset is in pairing mode,
»
which lasts five minutes.
Settings Connectivity
Select
Back
Enter Password
Settings
Devices Found
Select
Back
Philips SHB6000
Settings Connectivity
Bluetooth
Select
Back
Add
Bluetooth
device
4Pair the headset with the mobile
phone. For details, refer to the user
manual of the mobile phone.
*Available if suppor ted by your mobile phone.
Charge the headset
1Remove the USB cap.
2Plug the headset into a powered
USB port with USB charging
cable.
Get the best fit
1Choose the earbuds that best fit for
your ear canal.
2Gently blend the earhook to fit into
your ears.
3Adjust the rubber par t of the earhook
to the height that you feel fit.
4Twist the earbuds to the right position
for best fit and noise isolation.
The PIN code ''0000'' is not
required for some mobile phones.
SHB6000_QSG_EN.indd 4-6SHB6000_QSG_EN.indd 4-6 2010-8-2 11:00:002010-8-2 11:00:00