Philips Dynalite DDPB22RJ12 User manual

features
To reduce the risk of fire or electric shock, do not expose
this device to rain or moisture. Do not energise unless the
front cover is in place. This device must be earthed.
Installation, programming and maintenance must be
carried out by qualified personnel.
22 x RJ12 networking sockets. All network connection
points are paralleled together.
1 x 5 way network screw terminal. Common with all RJ12
sockets.
Allows for Dynet network to be run in a star topology
Enclosure is DIN Rail Mount with Circuit Breaker Profile
Simple Installation - DIN Rail mount facilitates installation.
All connection terminals are accessible without disassembly
Warning –This is a class A product. In a domestic environment
this product may cause radio interference in which case the user
may be required to take adequate measures.
Read Instructions –We recommend that you read this
Instruction Manual prior to commencement of installation.
Power Sources –This device should only be operated from the
type of supply specified on the front cover. This device must be
earthed.
Mounting Location –Install in a dry, well-ventilated location.
Controllers may emit some mechanical noise. Take this into
account when deciding the mounting location.
Data Cable –For 5 way screw terminal use screened, stranded
RS485 data cable with three twisted pairs. For RJ12 sockets use
Flat 6 way cable. Segregate from mains cables by 300mm
minimum. Connect on to other network devices in a ‘daisy chain’.
A data cable that is connected to an energised device is live. Do
not cut or terminate live data cables.
………
DDPB22RJ12
Network Junction Box
Electrical diagram
RJ12 Plug Connection diagram
All manuals and user guides at all-guides.com
all-guides.com

installation steps
product specifications
DDPB22RJ12 Installation Manual Rev A.doc Specifications subject to change without notice
Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: [phone] Fax: [phone]
E-Mail: [e-mail] Web: Philips.com/dynalite
Dynalite: DYNET-SFLAT6-CALBE
1. Mount the device on a DIN rail inside an approved enclosure.
2. If a CAT5 network cable is being used on site terminate in the 5 way screw connector as shown bellow.
3. When connecting flat cable, ensure that the recommended wiring connection is followed crimping on the RJ12 socket,
Re check the wire colours after crimping the RJ12 socket to ensure wires have located correctly on the right plug pins.
4. Plug RJ12 into any one of the 22 RJ12 sockets. .
Network connections 22 x RJ12 network sockets, 1 x 5 way screw terminal
Compliance: CE, C-Tick
Operating Environment: 0º to 50ºC ambient temperature, 0% to 95% RH non condensing
Construction: Polycarbonate DIN rail enclosure, 12 units wide
Dimensions: H 93mm x W 211mm x D 75mm
Weight: Packed weight 0.94kg
All manuals and user guides at all-guides.com