Philips PET738 User manual

Charge
1
Quick start guide
Philips Portable DVD Player PET738
3OPEN HERE
2Enjoy
1
2
1Connect the supplied adapter to the set and
the AC outlet.
2RED light turns on. 3The RED light comes on. 4The battery pack will be fully charged in
approximately 4 hours.When the RED light goes out, it means that the battery pack is fully charged.
TIP Your battery will continue to charge while the player is in use. However, the RED light will not be lit and it will take approximately 8 hours to fully charge the battery pack.
1Open the lid. 2Switch ON the set. 3The GREEN light turns on. 4Open the DVD door by pressing
the OPEN.
5Remove protective card (if any). 6Load the DVD disc. 7Close the DVD door and the set
will automatically start to playback.
8Use control keys on the set or
remote control.
1
2
8
7
6
4
3
3Analog TV
Antenna connection Before you start to search for TV channels, connect the DVD player to the antenna as shown. Setup you TV 1Press OPTIONS and select SOURCES >TV.
2In TV mode, press SETUP,the TV Setup menu
will be displayed to show the following available functions.
3Use 3/ 4key to select AUTO SEARCH, then
press OK.The system will remind you to select area first.
4Use 3/ 4key to select your country.
When area is set, the system will start auto search. After search is completed, the first channel found will be displayed.
Enjoy TV Press CH-/CH+ to change channels.
tv setup menu tv mode setup exit auto search ch. manage fine tuning
setup exit
china
setup exit
russia
usa
hongkong
india
PET738 QSG_Eng.qxd 2007.11.5 11:15 Page 1