Philips OR 7200 User manual

OR7200
Register your product and get support at
User manual

User Manual
OR7200
2 sec.

User Manual
OR7200
2 sec.

2 sec.

2 sec.
DAB+

2 sec.
DAB+

Congratulations on your purchase, and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
1 Safety
Read and understand all instructions before you use this product. If
damage is caused by failure to follow the instructions, the warranty
does not apply.
Risk of electric shock or re!
• Never expose the product and accessories to rain or water. Never
place liquid containers, such as vases, near the product. If liquids are
spilt on or into the product, disconnect it from the power outlet
immediately. Contact Philips Consumer Care to have the product
checked before use.
• Never place the product and accessories near naked ames or other
heat sources, including direct sunlight.
• Never insert objects into the ventilation slots or other openings on
the product.
• Where the mains plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
• Disconnect the product from the power outlet before lightning
storms.
• When you disconnect the power cord, always pull the plug, never
the cable.
Risk of short circuit or re!
• Before you connect the product to the power outlet, make sure
that the power voltage matches the value printed on the back of
the product. Never connect the product to the power outlet if the
voltage is different.

• Never expose the product to rain, water, sunshine, or excessive heat.
• Avoid force coming onto power plugs. Loose power plugs can cause
arcing or re.
Risk of injury or damage to the product!
• This product shall not be exposed to dripping or splashing!
• Do not place any sources of danger on this product (e.g. liquid lled
objects, lighted candles).
• Never place the product or any objects on power cords or on other
electrical equipment.
• If the product is transported in temperatures below 5°C, unpack the
product and wait until its temperature matches room temperature
before connecting it to the power outlet.
Risk of overheating!
• Never install this product in a conned space. Always leave a space
of at least four inches around the product for ventilation.
• Make sure that curtains or other objects never cover the ventilation
slots on the product.
Note
•The type plate is located on the back of the product.
Important notes for users in the U.K.
Mains fuse
This information applies only to products with a UK mains plug.
This product is tted with an approved non-molded plug. If you
replace the fuse, use one with:
• the ratings shown on the plug,

• a BS 1362 approval, and
• the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse to use.
Caution:To conform with the EMC directive (2004/108/EC), do not
detach the plug from the power cord.
How to connect a plug
The wires in the power cord are colored as follows: blue = neutral
(N), brown = live (L).
If the colors do not correspond with the colors on your plug, identify
the terminals in your plug as follows:
1 Connect the blue wire to the terminal marked N or colored
black.
2 Connect the brown wire to the terminal marked L or colored
red.
3 Do not connect either wire to the earth terminal in the plug,
marked E (or e) or colored green (or green and yellow).
Before you replace the plug cover, make sure that the cord grip is
clamped over the sheath of the cable and not just over the two wires
in the cable.
2 What’s in the box (Fig. 1)
3 Connect power (Fig. 2-1)
4 Turn on (Fig. 2-2)
Press the knob or turn the SOURCE knob.
» The product switches to the last selected source.
• To switch the product to standby mode, press the
knob again.