-This vacuum cleaner is designed for household use only. Do not use this vacuum cleaner to
vacuum up building waste, cement dust, ashes, fine sand, lime and similar substances. Never use
the vacuum cleaner without any of the filters. This could damage the motor and shorten the life of
the vacuum cleaner. Always clean all parts of the vacuum cleaner as shown in the user manual. Do
not clean any parts with water and/or cleaning agents if this is not specifically shown in the user
manual.
Caution
-Only charge the appliance with the adapter supplied. Only use 29V adapter ZD12D290050. The
corresponding adapter number can be found on the adapter.
-During charging, the adapter becomes warm to the touch. This is normal.
-Do not plug in, unplug or operate the appliance with wet hands.
-Do not remove the adapter from the wall socket by pulling at the cord (Fig. 1). When you do not use
the charging station for charging, always unplug the appliance by first detaching the magnetic
charging disc from the underside of the appliance (Fig. 2).
-Always switch off the appliance after use and before you charge it.
-Never block the exhaust air openings during vacuuming.
-Do not clean the dust container and the dust container lid in the dishwasher. They are not
dishwasher-proof.
-Make sure to wash the filter at least once every two weeks to ensure best performance.
-Do not clean the filter with scouring pads or abrasive cleaning agents.
-Always use the vacuum cleaner with the filter assembled.
-If you clean the filter with water, make sure that it is completely dry before you put it back into the
dust container. Do not dry the filter in direct sunlight, on the radiator or in the tumble dryer.
-Replace the filter if it can no longer be cleaned properly or if it is damaged (see 'Ordering
accessories').
-Never use any accessories or parts from other manufacturers or that Philips does not specifically
recommend. If you use such accessories or parts, your warranty becomes invalid.
-Use and store the appliance at a temperature between 5°C and 40°C.
-Make sure that the appliance is installed with the charging station attached to the wall according to
the instructions in the user manual.
-Be careful when you drill holes in the wall to attach the charging station, to avoid the risk of electric
shock.
-As this appliance uses water to clean, the floor may remain wet and slippery for a while (Fig. 3).
-To prevent damage, never put wax, oil, floor maintenance products or liquid floor cleaners that are
not water-dilutable in the water tank.
-Do not mix different types of liquid floor cleaner. When you have used one liquid floor cleaner, first
empty and rinse the water tank before you add another liquid floor cleaner to the water in the
water tank.
-To prevent damage, do not use liquid floor cleaners that are not transparent or even milky.
-Never exceed the maximum quantities mentioned on the bottle when you use a liquid floor
cleaner. Do not add more than a few drops to the water in the water tank, as this tank has a
capacity of 200ml.
-Do not clean the metal wetting strip with a sharp object, as this may damage the strip. Only clean
the wetting strip by rinsing it under the tap. Replace the wetting strip when you can no longer clean
it.
-Replace the wetting strip only with an original strip. For ordering a new strip, see chapter 'Ordering
accessories'.
-Clean the water tank according to the instructions. The water tank is not dishwasher-proof.
7
English
