Phoenix ACRYLICARRIER SMALL User manual

ASSEMBLY
INSTRUCTIONS
ACRYLICARRIER
SMALL
Getting started!
Read these notes first:
1. Review these instructions thoroughly before attempting to
assemble the carrier. If you still require , please contact
Acrylic Habitats Customer Service.
a. Phone: [phone]
b. Email: [e-mail]
c. Online: www.acrylichabitats.com
2. Review All Parts: If parts have been damaged or are missing,
please contact Acrylic Habitats Customer Service.
3. Tools: Phillips Screw Driver (not included). If using power tools,
please be careful not to overtighten any screws.
4. Two-person assembly is recommended for best results.
5. Protective Paper: Please note the orientation stickers on the
protective paper. Test fit all pieces before removing the paper. If any
of the protective paper sticks to the acrylic, we recommend using
Goo Gone or an ammonia free glass cleaner to remove excess glue.
6. Return Policy: Returns are ONLY accepted in the original
packaging with the protective paper still intact.
7. Visit www.acrylichabitats.com for tutorials and
assembly videos!
8. Please do not leave the carrier outside in direct sunlight. Acrylic
is an insulative material and may overheat.
assistance
Phoenix

Top
Bottom
Right Side
Front Back
Parts List
Left Side
Perches (4) 10.5”
Door Knobs with screws (1)
Stainless Steel Feeder Cups (2)
Door Jam with screws (1)
Phoenix
Acrylic Habitats Acrylic Habitats

Step 1
To assemble the back piece:
Lay the back of the carrier flat on a hard surface. Position the back piece so the
bottom is closest to you. Remove the screws from three 10” perches and mount
the three perches to the back piece. Tighten the screws.
Step 2
To assembly the top, bottom, and side pieces:
Attach the top and bottom pieces by gently pressing the pegs into the plugs on
the back piece.
Attach the right piece onto the back by gently pressing the pegs into the plugs
(please note the orientation of the logo). Remove the screws from the last 10”
perch and mount the perch onto the right-side piece. Attach the left-side piece
and screw the perch into the left-side piece. Make sure that all the pegs are
secured into their plugs.

Step 3
To assemble the front piece:
Open the door, place the front piece onto the carrier and gently press the pegs
into the plugs. Take three screws and secure the three perches extending from
the back piece into place.
Install the door jam on the inside of the carrier. The door jam goes on the inside
of the carrier, but it is screwed on from the outside (Fig 3-1)
Install the door knob. Tighten the screw from the back of the door (Fig 3-2).
Fig 3-1
Fig 3-2
Step 4
To add the feeder cups:
Flip the unit up right so the bottom piece is now flat on the hard surface.
Gentle screw in the two feeder cups to the inside of the door.
THE CARRIER IS NOW FULLY ASSEMBLED AND READY FOR USE.
CLEANING & CARE INSTRUCTIONS
1. When cleaning the carrier, use an ammonia free glass cleaner or mild dish
soap. We recommend SprayWay Cleaner.
2. After washing, dry the carrier thoroughly with a soft cotton cloth to prevent
scratches or residue. Do not leave in the sun to dry.
3. Any minor hazing or fine scratches can be buffed out with a plastic polish.
We recommend Novus Polish #2.
4. For worn or soiled perches, replace with untreated wood dowels.
Phoenix