Pineapple HUSH 800.496.9324 User manual

REQUIRED
ITEMS
HUSHACOUSTICPANELS WALLFIXING
Long straight edge
Spirit level
Evo-Stik “Sticks Like” adhesive
Applicator/caulking gun
Tile spacer (supplied)
800.496.9324
T
E
[e-mail]

04
01
Measure out the space needed to be covered
(depending on number of tiles).Mark out the
area and add a centerline using tape.
02
03
For a non-permanent fixing of HUSH
consider using a backing panel such as
plasterboard.
Prepare the adhesive by following the
instructions on the tube and insert into the
cartridge gun
Apply a thin bead (approx. Ø0.1”) of adhesive
to the back edges of the panel along the
center of the face
T
E
HUSHACOUSTICPANELS WALLFIXING
800.496.9324
[e-mail]

05
Fix the panel to the wall using the centerline
as a guide.Ensure the panel is firmly stuck on
all four edges
T
E
HUSHACOUSTICPANELS WALLFIXING
06
Using the spacer tool if necessary, build up
the desired pattern
Use a spirit or laser level to ensure the panels
reman aligned
07
08
The panel’s position can be adjusted for up
to 15 minutes.Wipe off any excess adhesive
with a cloth or white spirit .
Leave to cure for 24 hours.
800.496.9324
[e-mail]

Please read all instructions carefully to ensure proper installation.Failure to read and
follow instructions may result inadequate product installation and a void of warranty
Pineapple shall not be held liable for any consequences caused by the improper
installation of products to the installer or the end user
T
E
DISCLAIMER
800.496.9324
[e-mail]