Pineapple RYNO CHAIR User manual

REQUIRED
ITEMS
RYNO®CHAIR FLOORFIXING
2 x fixing plates
(only provided with floor fixed version)
6 x M10x20 security screws
(only provided with floor fixed version)
6 x floor fixing bolts
(only provided with floor fixed version)
1 x handheld power drill
1 x masonry drill bit
1 x drill bit holder
1 x T45 security drill bit
Wrench/socket set
Hammer
These instructions apply only when fixing to a concrete floor with no obstructions (e.g. under floor heating, cables,
plumbing, etc.). When fixing to any other surface,or with obstructions, please contact your Pineapple representative
for further advice
[phone]
T
E
[e-mail]

04
01
Turn the chair upside down on a clean
surface,laying the chair on a furniture
blanket to protect the chair
02
03
Position fixing plate over the threaded
inserts on the bottom of the chair so that the
countersunk holes are in line with the inserts.
Using your fingers, screw the bolts through
the plate and into each insert
Once you have all three bolts in position, use the
drill to tighten them down.The plate should now
be in position and secure. Repeat the process
with the remaining fixing plate on the other side
Set product into required position and mark
off the centre of each position to be drilled
through the fixing plate
[phone]
T
E
[e-mail]
RYNO®CHAIR FLOORFIXING

05
Move the product to one side and drill out the
marked drill points to the required depth
using masonry drill bits (drill a pilot hole to
begin with using a smaller bit). Carefully tap
the floor fixing bolts into each drilled
hole using a hammer
06
07
Remove the top nut from each bolt, place the
product into position over the exposed threads,
then re-screw each nut back onto the bolt
threads and tighten down by hand.The collar
on each bolt should feed into the hole on the
fixing plate
Once you have all the nuts securely in place,
use a wrench and socket to tighten each nut
down until the nut head shears off from the
domed cap
[phone]
T
E
[e-mail]
RYNO®CHAIR FLOORFIXING

[phone]
T
E
[e-mail]
DISCLAIMER
Ensure the proper and adequate hardware is used to secure furniture
Ensure fixings are appropriate for the anchoring material
Use fixings of an appropriate strength and consider using security fixings in
challenging environments
Consider using high strength thread-locker on fixings in challenging environments
Ensure all gaps are sealed with the appropriate anti-pick mastic after product
installation if necessary
Please read all instructions carefully to ensure proper installation. Failure to read and
follow instructions may result inadequate product installation and void of warranty
Pineapple shall not be held liable for any consequences caused by the improper
installation of products to the installer or the end user