Pineapple RYNO BENCH User manual

REQUIRED
ITEMS
RYNO®BENCH FLOORFASTENING
2 x floor brackets
(only provided with floor fixed version)
2 x M6 screws
(only provided with floor fixed version)
8 x M8 washers
(only provided with floor fixed version)
8 x concrete hardware fastenings
Handheld power drill
1 x masonry drill bit
Wrench/socket set
1 x T27 security drill bit
Straight edge for floor fixing
These instructions apply only when fixing to a concrete floor with no obstructions (e.g. under floor heating, cables,
plumbing, etc.).When fixing to any other surface,or with obstructions, please contact your Pineapple representative
for further advice
[phone]
T
E
[e-mail]

04
01
Ensure Brackets are fully fastened to the
base of the bench. Measure between the two
closest holes of the two brackets and make
note of this dimension
02
03
Place one bracket on the ground ensuring
it is the correct distance from any walls as
shown in the diagram. (90mm from a back
wall and 60mm from a side wall). Place down
the second bracket the distance apart as
previously measured in step 1.
Place the straight edge at the back of the
brackets to ensure they remain parallel. Drill
though one hole in each bracket ensuring they
do not move.And put in the concrete hardware to
hold the brackets in position.Drill through all the
remaining holes and place in hardware as you go
along to ensure the brackets stay in position. (If
the floor is especially uneven, place the included
washers under the brackets to level them before
fixing the brackets to the ground.)
Place bench onto brackets and flush to floor,
ensuring brackets line up with the indents
on the underside of the product.Then, push
back until brackets hook into the product.
RYNO®BENCH FLOORFASTENING
[phone]
T
E
[e-mail]

Ensure the proper and adequate hardware is used to secure furniture
Ensure fastenings are appropriate for the anchoring material
Use fastenings of an appropriate strength and consider using security fixings in
challenging environments
Consider using high strength thread-locker on fastenings in challenging environments
Ensure all gaps are sealed with the appropriate anti-pick mastic after product
installation if necessary
Please read all instructions carefully to ensure proper installation. Failure to read and
follow instructions may result inadequate product installation and void of warranty
Pineapple shall not be held liable for any consequences caused by the improper
installation of products to the installer or the end user
DISCLAIMER
05
Insert M6 screws into the front of the product
and ensure correct location into brackets.
Start both screws by hand to ensure no
risk of cross-threading.Finally tighten each
one fully ensuring the product moves back
evenly.
[phone]
T
E
[e-mail]