PinGuard T9+ User manual

3X
1X
1X
Important Information Please Read First
• Warning! Do not t when surface temperature is below 10°C/50°F (see Adhesive information)
• All safety equipment to be provided by installer
• Fitting template is a guide and for some ATMs may not be needed
• For all Material Safety Data Sheets please email [e-mail]
• For full terms and conditions please email [e-mail]
Adhesive Information
The VHB tape adhesive takes 3 days to reach full 100% strength. The VHB adhesive is covered in microscopic bubbles lled
with liquid adhesive. When the tape is pressed onto the ATM fascia, the pressure bursts the bubbles and releases the liquid
adhesive that bonds to the ATM. When the environment is cold (which is why we say not to t below 10°C/50°F) the liquid
doesn’t ow correctly which makes the bond weak. Also if there is any grease, moisture or dirt on the surfaces this will
greatly reduce the bond strength and may cause the bond to fail (this can be seen if there is no adhesive residue left over
on the ATM fascia). The primer helps the adhesive bond to the ATM and speeds up the curing process.
For other translations of this instruction sheet please email suppor[email protected]om
Tel: [phone]
Email: [e-mail]
T9+
Instruction manual
T9+
Instruction manual
Instruction Manual

Fitting Instructions
NOTE:
•
NOTE:
•
Step 1: Open cleaning sachet.
Step 5: Peel tape from the base of the PINGuard® ensuring that you do
not touch the adhesive surface.
Step 3:
black dot on the container, which will produce
a popping sound, Keep squeezing the dot
until liquid appears on the application pad at
the end of the ampoule and continue doing
so until all the liquid has beenused.
Step 2: Thoroughly clean the area shown using
cleaning sachets provided. All three sachets
may be required to ensure that it is absolutely
clean . The area around the PIN Pad must be
completely clean for the best adhesion. Allow
to dry for 5 minutes.
Step 4: Brush the primer onto the area shown. Ensure
complete coverage of PINGuard® footprint
area. Allow to dry for 5 minutes.
Step 6: Once correctly aligned and fitted, apply heavy pressure to the base for at least 2 minutes! This will remove any air bubbles and is vital for
good adhesion. Leave for 5 minutes for bond to cure.