Piranha 900016 User manual

PIRANHA MAGNUM
1800W Vacuum Cleaner
USER MANUAL
MODEL NO:
90001

Handle with Suction
Control knob
Floor Brush
Flexible Hose
Dust Canister with
HEPA Filter
Cord Retractor
Knob
Power Control Dial
Exhaust Filter
Handle
ON/OFF Switch
Crevice Tool Accessory
Brush Accessory
On Board Tool
Holder
Dust Canister
Release button
DESCRIPTION
IMPORTANT
•Read this instruction booklet carefully before operation.
•Before using the appliance, check that the mains power voltage
corresponds with the voltage shown on the rating plate.
•Always remove the plug from the power socket when the appliance is not
in use and before carrying out any maintenance operations.
•Always remove the plug from the power socket before opening the
appliance.
•Do not use the appliance to vacuum liquids due to electric shock hazard.
•Never leave the appliance unattended when it is switched on.
•The appliance is not intended for use by young children or infirm persons
without supervision.
•Young children should be supervised to ensure that they do not play with
the appliance.
•This appliance is for domestic use only. Commercial use voids warranty.
Use as described in this instruction booklet.
•Do not switch the appliance on if it appears to be faulty in any way. For
repairs or accessories contact the distributor on the contact details
outlined in the guarantee.

PIRANHA MAGNUM MAXIMUM PARTICLE FILTRATION
SYSTEM
HEPA (High Efficiency Particulate Air) filters are an effective system in
removing almost all indoor pollutants, dust mites, pollen and mould spores.
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power socket before fitting or
removing accessories
Fitting the Flexible Hose
Insert the flexible hose into the hose socket
on the front cover of the appliance. Press
the flexible hose into the hose socket until
the hose clicks into place.
Removing the Flexible Hose
To remove the flexible hose, press the
locking buttons on the base of either side of
the flexible hose to release the lock. Pull
the flexible hose out of the hose socket.
Fitting the Telescopic Tubes and
Accessories
Attach the telescopic tubes to the curved
handle of the flexible hose. To extend the tubes,
push on the button at the centre join and pull the
inner tube outward.
Attach the preferred cleaning accessory to the end of
the telescopic tube.
Removing the Telescopic Tubes and Accessories
To remove the plastic tubes and accessories, hold each piece tightly and pull
firmly apart.

OPERATION METHOD
1. Unwind the length of power cord required and
insert the plug into the power socket. A YELLOW
mark on the power cord indicates the ideal cable
length. Do no extend the power
cord beyond the RED mark.
2. Press the On/Off Switch Pedal to
switch the appliance ON.
3. Adjust the Suction control knob on the curved handle to
control the suction. The suction will be reduced with a larger
air opening.
4. Adjust the Power Control Dial to the Min or max Power setting you require.
This function controls the power of the motor. It is recommended to keep it on
Max to receive full benefit from the vacuum.
Retracting Cord
To rewind cord press the cord rewinding pedal. CAUTION: Cord retracts very
quickly. Take care to avoid injury.
Using the Cleaning Accessories
•Dual position carpet / floor brush
Position 1: Bristles extended Position 2: Bristles retracted
- For hard floors - For carpets
•Integrated Brush and Nozzle
For cleaning radiators, corners edges, drawers, curtains shelves, books,
inlaid furniture, lamps and other delicate objects.

MAINTENANCE
NOTE: Always remove the power plug from
the wall outlet before carrying out any
maintenance.
Cleaning the Dust Canister
1. Remove the flexible hose from the hose
socket.
2. Press the Dust Canister release button
and lift out from the housing.
3. To open, twist and slide the dust
container out of the housing using the
handle. Empty contents into a rubbish bin.
4. To close the container it is important that the 2 arrows (as shown below) are
matched and the dust container has been clipped securely into the lid.
5. Once the base container has been
clipped into place, twist towards the
centre arrow to lock in place.
6. Fit the dust container back into the
vacuum cleaner.
This groove
must be
clipped into
the lid
Twist and slide to open dust container

Maintaining Filters
It is very important to keep the filters clean to receive maximum
performance from the vacuum. Not cleaning and not replacing your
filters regularly can reduce the suction power and cause overheating.
1. To clean pre-motor filter, Lift the dust canister
out and remove the filter from its housing
2. Wash under running water and allow the filter to
dry completely before replacing it in the vacuum.
3. To clean the HEPA filter, remove the filter from the dust
container. To remove the HEPA filter from its housing,
twist clockwise. Shake or brush away dust from filter
and replace.
4. To clean the exhaust filter, detach the grill by pulling
firmly away from the appliance.
5. Remove the filter and wash under running water and
allow to dry completely before replacing it in the
appliance.
6. Hepa Filters should be replaced approximately every few months depending
on how frequently the appliance is used.
Pre
-
Motor Filter
HEPA Filter
Exhaust Filter