Piranha FORCE 900129 User manual

PIRANHA FORCE
1800W Bagless Cyclonic Vacuum
With Motorised Floor Brush
USER MANUAL
ITEM NO: 900129

PARTS DESCRIPTION
Cord Retract Button
Fixed Carry Handle
On/Off Switch
Motor Speed Control
Dust Container
Release Button
Dust Container Handle
HEP
A
Filter
Dust Release
Button
Dust Container
Piranha Force Vacuum
Vacuum Exhaust
Exhaust
Grill
Exhaust Filter
Exhaust
HEPA Filter
Mesh Filter
HEPA Filter
Motorised Floor Brush
Adjusted Height
Indicator
Height Adjustor
Extendable Tube &
Power Supply
Connector

IMPORTANT
•Read this instruction booklet carefully before operation.
•Before using the appliance, check that the mains power voltage corresponds with
the voltage shown on the rating plate.
•Always remove the plug from the power socket when the appliance is not in use
and before carrying out any maintenance operations.
•Always remove the plug from the power socket before opening the appliance.
CAUTION: This hose contains electrical connections:
•Do not use the appliance to vacuum liquids, due to electric shock hazard.
•Do not immerse in water for cleaning;
•The hose should be checked regularly and must not be used if damaged.
•Do not use the appliance to vacuum sharp objects.
•Do not use the appliance to vacuum lighted cigarettes, hot ashes and any other
combustible objects.
•Do not use the appliance to vacuum tiny particles like cement or plaster dust as
this will shorten the life of the motor.
•Keep the vacuum cleaner away from stoves, heaters and any other heat emitting
appliances. Heat can deform and discolour the plastic parts.
•Do not block the air flow. Blocking the suction in any way (e.g. blocked filters,
blocked hose or full dust bag) will decrease the efficiency and will shorten the life
of the motor.
•Do not run the vacuum cleaner over the power cable.
•Never leave the appliance unattended when it is switched on.
•The appliance is not intended for use by young children or infirm persons without
supervision.
•Young children should be supervised to ensure that they do not play with the
appliance.
•This appliance is for domestic use only. Commercial use voids warranty.
•Do not unplug by pulling the power cord. Always unplug by pulling the plug.
•Use as described in this instruction booklet.
•Do not switch the appliance on if it appears to be faulty in any way.
•For repairs or accessories contact the distributor on the contact details outlined in
the guarantee.

PIRANHA FORCE MAXIMUM PARTICLE FILTRATION SYSTEM
HEPA (High Efficiency Particulate Air) filters are an effective system in
removing almost all indoor pollutants, dust mites, pollen and mould spores.
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power socket before fitting or
removing accessories
Fitting the Hose and Adapter for Motorised Floor
Brush
Insert the flexible hose into the hose socket on the front
of the appliance. Squeeze the locking buttons on the
flexible hose together and push into the hose socket
until the hose clips into place.
For use with motorised floor brush, plug the adapter as
shown into the socket above the hose fitting. Ensure the
hose has been fitted securely beforehand to avoid unnecessary
pulling to the adapter cord.
Fitting the Telescoping Tubes and
Accessories
Attach the telescoping tubes to the curved handle
of the flexible hose.
To extend the tubes, push on the button at the centre join
and pull the inner tube
Attach the preferred cleaning accessory to the end
of the telescoping tube.
For use with the Motorised Floor Brush, ensure the
Telescoping tube is inserted to the floor brush
connector securely. There should be no gaps

Removing the Telescoping Tubes and Accessories
To remove the telescoping tubes from the curved handle and Motorised Floor
Brush, press on locking tabs (as shown), hold each piece tightly and firmly
pull apart.
To remove standard floor brush and small
tools, hold each piece tightly and firmly
pull apart.
OPERATION METHOD
1. Unwind the length of power cord required and insert the plug into the
power socket. A YELLOW mark on the power cord indicates the ideal
cable length. Do no extend the power cord beyond the RED
mark.
2. Press the On/Off Switch to switch the appliance ON.
3. Adjust the motor speed control to the desired setting. This
function controls the power of the motor. From Min being the
lowest motor speed to Max at the highest motor speed. It is
preferable to set the speed to Max to obtain the highest suction.
Retracting Cord
4. To rewind cord press on the cord retract button (by
hand or by foot).
CAUTION: Cord retracts very quickly. Take care to
avoid injury.
It is recommended that you hold the plug
whilst retracting the cord. When the cord has shortened, let go
of the plug until fully retracted, this will avoid the plug from
flicking around.
Using the Cleaning Accessories
5. Dual position carpet / floor brush
Position 1: Bristles extended for hard floor
Position 2: Bristles retracted for carpets
Press on Tabs
to remove
tubes and
accessories
Position 1
Position 2

6. Integrated Brush and Nozzle
For cleaning hard to reach places eg. corners edges, drawers, curtains
shelves, books, furniture, lamps and other delicate objects.
7. Upholstery Tool
For cleaning dust furniture, curtains, lamp
shades etc.
Motorised Floor Brush
Ideal for use on carpets and cleaning after indoor pets.
8. Step 1: Connect the adapter to the socket on the vacuum. Step 2: Insert
the telescoping tubes to the hose and; Step 3: Attach the motorised Floor
Brush the end of the tubes. The floor brush will not operate unless all
these connections are secured.
9. Adjust the height of the Floor brush according to the floor type by pressing
(by foot or by hand) on the right hand pedal. There are four height settings
0, 1, 2 and 3. With every stroke of the pedal, the floor brush will rise in
height.
Height Suitability
0 – For hard floors (tiles, vinyl, wood) or very short
pile carpet.
1 – Short to Medium pile carpets
2 – Medium to long pile carpets
3 – Long pile carpets (shag, plush or scatter rugs)
10.The handle can be released from the locked position
on the motorised floor brush for easy manoeuvring
whilst vacuuming. Press the middle pedal to release
(by foot or by hand). The handle will lock back into
place one pushed into the upright position.
11.To activate the motorised floor brush, press the
ON/OFF switch on the handle.
Height
Setting
Indicator
Step 1 Step 2 Ste
p
3

MAINTENANCE
Always remove the plug from the power socket before performing any
maintenance.
Cleaning the Dust Container
1. Remove the flexible hose from the hose socket and unplug
the adapter for the motorised floor brush.
2. Press the dust container release button and pull the
container out of the vacuum.
3. Hold container over a rubbish disposal bin then press
button to open the base of the container and dispose of
contents.
4. Close the container and replace in the housing.
Maintaining Filters
It is very important to keep the filters clean to receive maximum
performance from the vacuum. Not cleaning not replacing your filters
regularly can reduce the suction power and cause overheating.
5. To clean the HEPA filter and mesh filter,
remove the dust container from its housing.
Press the spring clip to Release the HEPA
filter as shown and pull the filter out.
6. The HEPA filter can be cleaned by brushing
the dust off, washed under running water
or by soaking in warm soapy water.
7. It is important that the HEPA filter has dried
thoroughly before refitting for use.
8. To clean the exhaust filter, detach the back
grill by pressing on the release clip and
pulling firmly away from the appliance.
Remove the filter and wash under running
water and allow to dry completely before
refitting it in the vacuum for use.
9. Filters should be replaced approximately
every 4-6 months depending on how
frequently the appliance is used.
10.Filters can be purchased direct from the
distributor. Call the customer service centre
on 1800 079 124 for details.
Press the dust
release button
Release Cli
p

GUARANTEE
WHAT’S COVERED
H. E. Group Pty Ltd guarantees Piranha Force 1800W Bagless Cyclonic
Vacuum Cleaner for a full replacement for a period of 2 years from the date
of purchase, which is only valid with the presentation of the original proof of
purchase receipt. This guarantee covers materials and workmanship defects
only.
WHAT IS NOT COVERED
This guarantee does not apply to defects arising from abuse, alteration or
unreasonable use of the product. In addition, it does not cover general
deterioration due to usage.
This guarantee does not apply to the standard floor brush, accessories and
belt in the motorised floor brush due to general deterioration.
WHAT H. E. GROUP PTY LTD WILL DO
H. E. Group Pty Ltd will replace the product, if a defect is discovered whilst
under the guaranteed period, subject to verification of defect or malfunction,
date and proof of purchase.
CUSTOMER CARE
All enquiries may be directed to our friendly customer service team on toll free
number: 1800 079 124 or via email [e-mail]