Planet HDVR-M15 User manual

Verify The Contents Inside Package Box
The package box should contain the items indicated below. If any item
is missing or damaged, please contact the seller immediately.
Package Content:
1. Bracket
2. Bayonets
3. Copper Column
4. HDVR-M15
Attention: After installed the HDVR-M15 into HDVR-1600, the hardware
structures will be changed, and the existing HDD need to
format for different database forms. We are suggest to
backup your videos before starting the below installations,
or to prepare another new HDD for recording purpose.
STEP 1: Connect the bayonets to the bracket. The socket should face
downward.
STEP 2: Mount the bracket onto the HDVR-M15. Be careful to avoid
overlapping the pins placed in front of the fan.
STEP 3: Power off the HDVR-1600 and unplug everything from it.
Unscrew the 8 screws holding the top cover in place (3 at
each side, 2 at the rear). Remove the top cover by sliding it
to the rear.
STEP 4: Unscrew the screw marked in the picture. Keep the screw
for later use. Then install the copper column to the same
position.

STEP 5: Install the HDVR-M15 into the socket. Then fasten the screw
kept in advance to the copper column.
STEP 6: Connect the power cable to the HDVR-M15. This will provide
power supply for the fan on the HDVR-M15.
STEP 7: Put the HDVR-1600’s top cover back and fasten the 8 screws
to their original spots.
STEP 8: After system boot up properly, it may warn the disk error,
you have to format the HDD and active it for recording
purpose.
STEP 9: Go to “Main Menu ‡4.Record Setup ‡1.Record Mode Setup”
menu, the Max. Rec PPS can promote up to 120 /100
(NTSC/PAL) fps at H.264 @ D1 format.
2011-AB5210-000
HDVR-M15
Quick Installation Guide