Plasson Nipple Drinker System User manual

Nipple Drinker System Installation Manual
When nailing the planks
together, ensure that the
gaps between them
line up straight
3m (10')
Working space
2mm (0.08") 21mm (0.8")
30mm (1.2")
34mm (1.3")
0.85m
(2'9")
6.1
6
5
4
3
2.1
2
1
Global Presence - Local Commitment

Nipple Drinker System Installation Manual
Nipple Drinker System Installation Manual
Make sure all trays are facing the same direction.
Lubricate the
rubber seal with
silicone grease.
Warning: Silicone
lubricants may be used, but do not use oil, grease
or soap as a lubricant: they will damage the
components.
12.1
9
8
7.17
14
15
16
11
10
12
13 14.1

Nipple Drinker System Installation Manual
Nipple Drinker System Installation Manual
When assembling the
line, make sure to
position each segment
of the line, with the leg
side of the tray facing
into the flow direction.
17
17.1
18
19
20
35.5mm (1.4")
ø8mm (0.3")
10.1mm (0.4")
21
21.1
21.2
21.3
22.1 22.2 22.3
22.4 22.5
Do not
tighten the
screws at
this stage.
22
Air ow direction

Plasson Poultry Division, 105 Ilan St. P.O.B. 108 North Industrial Estate Or - Akiva 30600, Israel
Tel: [phone] Fax: [phone] E-mail: poultr[email protected].il www.plassonpoultry.com
03/11 - 6804
Nipple Drinker System Installation Manual
25.1
25
24.1
24
26 27
28
30
29
Install a suspension and winching system above the
chosen location of the line. Make sure all pulleys are
properly aligned at intervals not exceeding 3.0m (10')
and that the first pulley is located directly above the
beginning of the first section
•Filtermustbeinstalledbeforelineheaderkit.
•Ifwaterissuppliedfromaheadertank,thehightof
the header tank bottom must be at least 3 m (10')
above floor level.
•Ifwaterissuppliedfromamainpipeline,In-coming
pressure to header kit should be 1.5 bar (22 psi), max. 2
bar (30 psi).
•Linesmustbelevel.Maximumpermitteddropofline
without slope regulator: 15 cm (6").
•Ifthereisaslope,thewaterinlets(lineheadkit)must
always be on the upper side.
•Maximumlengthofline:120m(400').
Some restrictions may apply in breeder, pullets and
turkey houses. See individual instructions.
•Whenusingashockerwire,install4suspensionclips
per section.
•Linesshouldbeparalleltotheoor.
•Cordadjustershouldbepositionednearthealuminium
profile so that between flocks, the system can be raised
as close as possible to the ceiling.
•Beforeoperatingthesystem,thesystemmustbe
flushed thoroughly with high pressure.
General instructions
After the entire line has been
assembled, make sure it is properly
aligned, without distortions. Then
tighten up all the nuts on the
connecting pieces.
23
23.1
Global Presence - Local Commitment