
INSTALLATION INSTRUCTIONS CONTINUED
1. Locate a beam minimum 4cm wide, and a site with 1 metre radius
from any objects.
2. Use base plate to mark holes in beam. Use 12mm bit to drill to
5cm depth into beam.
3. Insert 4 bolts into holes, so metal sleeve is flush with beam. If
beam can’t accommodate 4 bolts, 2 are sufficient.
4. Install base plate onto bolts, and tighten to secure bolt, sleeve,
and plate into beam.
5. Connect carabiner to plate, thread rope through swing and
carabiner, and adjust length accordingly.
The tools you need:
• Step ladder
• Stud finder
• Pencil
• Drill with drill bits
• Socket wrench
Before use, check for durability. The hook should withstand 85kgs of load.
To hang the daisy chain on the ceiling hook, just do the following 3 steps:
1. Put the chain through the metal hole,
2. Run one end of the chain through the other,
3. Tighten the loop.
In order to enjoy the swing you may mount the daisy chain in any place that will allow to
tighten the loop. Always make sure that the element the chain is mounted on will hold the
child’s weight.
Now you can go ahead and hang the swing using the carabiner hook. In order to adjust the
height, just hook the carabiner hook onto corresponding daisy chain loop.
DISCLAIMER
Our sensory swing is intended for ages 3 years and up, but may be acceptable for younger children
provided constant adult supervision and care.
Adult supervision is required at all times. To prevent injury only one person at a time should use the swing.
Please inspect the daisy chain strap occasionally to prevent breaks and reposition the fabric periodically to
prevent excessive wear in one spot.
Play’n’Learn assumes no liability for injury sustained through the use of this product.