Playskool Playskool Busy Pop-n-Hide Monkey 09372 User manual

Thank you for choosing this
PLAYSKOOL toy!
x2
BATTERIES INCLUDED
1.5V AA or R6 size
Replace with 2 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross head
screwdriver (not included) needed to replace batteries.
busy
basics
™
busy
pop-n-hide
monkey™
09372
ages &
stages®
months
9
OVER
to play

ages &
stages®
months
9
OVER
• With the BUSY POP-N-HIDE MONKEY™ toy, your
child will discover new jungle friends and enjoy
the monkey pop up surprise over and over again!
• Have your child push down on an animal, and
listen to either the fun “ROAR!” of the lion or the
friendly “TOU-CAN” call of the chattering toucan.
• At varied intervals, the monkey will pop up out of
the tree, surprising and delighting your little one!
to play

IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be
sure to insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
battery. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
to replace
batteries
Use a Phillips/cross
head screwdriver (not
included) to loosen screw
in battery compartment
door (screw remains
attached to door).
Remove door. Remove
old batteries. Insert 2
“AA” or R6 size batteries.
Alkaline batteries
recommended. Replace
door and tighten screw.

Questions? Call 1-800-PLAYSKL
7HRHS
7HRHS
 BNL  BNL
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
© 2007 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
Patent Pending.
09372 PN 6730480000