Plumbline AP60 User manual

T 04 568 9898 E [email protected] www.plumbline.co.nz
Distributed by:
INSTALLATION INSTRUCTIONS
CLAYBROOK WALL HUNG BASINS| AP60/DE56/AY45
Pencil
Drill
Silicon Gun Tape Measure
Tools Required For Installation (Not Included)
NOTICE:
1. Check for any damge prior to installing the basin
2. Do not leave any tools sitting inside the basin as this can damage the surface
MAINTENANCE
Use a soft moist cloth for cleaning the basin. Do NOT use abrasives or hard cloths. Regular cleaning with a soap
solution is recommended. Do NOT use strong bleaching agents. If acid liquids penetrate the surface, remove them
immediately with a soft cloth.

T 04 568 9898 E [email protected] www.plumbline.co.nz
Distributed by:
INSTALLATION INSTRUCTIONS
CLAYBROOK WALL HUNG BASINS| AP60/DE56/AY45
1. Refer to the specification sheets on the website to locate where the supplied brackets will sit.
2. Fix the brackets directly to the framing prior to installing the wall-lining as pictured below.
IMORTANT: BRACKETS MUST BE INSTALLED AS SHOWN BELOW, INSTALLING THESE UP-
SIDE DOWN CAN CAUSE STRESS ON THE BASIN CAUSING IT TO CRACK.
4. Place the basin on the brackets and apply a bead of silicon around the back edge. Finally fit off
with tapware, waste and bottle trap.
3. After installing the brackets, ensure they are sitting level.