Plumbline Progetto OL040 User manual

INSTALLATION INSTRUCTIONS
OLI316 KITCHEN MIXER ROUND SPOUT | OL040
OLI316 KITCHEN MIXER STRAIGHT SPOUT | OL041
OLI316 KITCHEN MIXER STRAIGHT SPOUT W POS | OL044
OLI316 KITCHEN MIXER ROUND SPOUT W POS| OL046
!IMPORTANT!
Please read these instructions prior to installation
T04 568 9898 E[email protected]
www.plumbline.co.nz
Distributed by:
OL040OL041
OL046OL044

2
max 5
min 1
1 - 3
Water Pressure
1 - 3 bar
RECOMMENDATIONS FOR INSTALLATION
max 80
60
45 Water Temperature
45° - 65°C
Stop Taps
Angle valves are recommended
Pre-Flush
Always ush out the pipework
before connecting any tapware.
!ATTENTION
Failure to do so will void
the warranty.

3
CLEANING AND MAINTENANCE
Cleaning
Clean with warm soapy water and a smooth
cloth. Avoid abrasive sponges or detergents
as these will damage the nish.
Aerator Maintenance
Unscrew the aerator with 22mm spanner
immerse for half a day in water-vinegar
solution (80-20%)
Wash, then reassemble

4
Screw the exible hoses into the water inlet
at the bottom of the mixer body, x them by
hand.
2
Screw the threaded rods into the holes at
the bottom of the mixer body and x them
by hand.
Insert the handle on the cartridge, then
fasten the screw using the 2.5mm hex key.
1
INSTALLATION INSTRUCTIONS
OLI316 KITCHEN MIXER ROUND SPOUT | OL040
OLI316 KITCHEN MIXER STRAIGHT SPOUT | OL041

5
Slide the base and the o-ring over the mixer
assembly then insert the whole block into
the basin hole.
3
BASE
O-RING
While holding the mixer in place, slide in
the rubber gasket and the metal washer
of the xing kit.
Secondly screw the two nuts on the
threaded rods and x them using a wrench.
4
!ATTENTION
Two operators are required to avoid
damages.
OL040 OL041

6
Screw the exible hoses into the water inlet
at the bottom of the mixer body, x them by
hand.
2
Screw the threaded pipe into the hole at
the bottom of the mixer body and x it by
hand.
Insert the handle on the cartridge, then
fasten the screw using the 2.5mm hex key.
1
INSTALLATION INSTRUCTIONS
OLI316 KITCHEN MIXER STRAIGHT SPOUT W POS| OL044
OLI316 KITCHEN MIXER ROUND SPOUT W POS| OL046

7
Slide the base and the o-ring over the mixer
assembly then insert the whole block into
the basin hole.
3
BASE
O-RING
While holding the mixer in place, slide in
the rubber gasket and the metal washer
of the xing kit.
Secondly screw the nut and the tting on
the threaded rod and x them using a
wrench.
4
!ATTENTION
Two operators are required to avoid
damages.

8
Connect one end of the exible
hose to the hand shower, then insert
the other end into the mixer spout.
Slide the exible until it comes out from the
mixer base.
5
Connect the exible hose to the tting at the
base of the mixer and x it by hand
6
OL044 OL046