Point Mobile PM67 User manual

Quick Start Guide
V1.0, Jun 2021
Copyright © 2021 Point Mobile Co., Ltd. All rights reserved.
Point Mobile Co., Ltd. is the designer and manufacturer of mobile handheld devices.
The Point Mobile logo is a registered trademark and symbol of Point Mobile Co., Ltd.
Features and specifications are subject to change without prior notice.
PM67

Device Parts
1. Receiver
2. LED indicator & Sensor
3. Touch screen
4. Software buttons
5. USB Type C connector
6. I/O connector
7. Keyapd
8. Scan button (Left)
9. Volume buttons
5
9
3
4
2
1
8
76

Device Parts
10. Rear camera & Flashlight
11. Battery cover
12. Battery cover release button
13. Hand strap hole
14. Speaker
15. Scan button (Right)
16. Power button
17. Scanner
15
17
10
11
14
12 13
16

Product Standard Accessories
Country plug
Standard battery
USB type C cable
LCD protection film
Product Optional Accessories
4 Slot Cradle
Single Slot Cradle
Gun handle
4 Slot Battery Cradle
Single slot Ethernet Cradle
Hand strap
Stylus pen
AC/DC power supply

Install SIM, SD card
PM67 supports micro SIM and microSD card. (SIM card is
supported by LTE SKU only.)
1. Open the battery cover while pressing the battery cover
release button. Pull the cover up using small hole on both
sides.
2. Insert the SIM card and SD card into proper slot in the
correct orientation. (Gold contact must be facing down.)
Install Battery
1. Open the battery cover while pressing the battery cover
release button.
2. Insert the battery from top to bottom with the contacts
facing down.
3. Close the battery cover from the top and close it firmly.
Micro
SIM
Micro
SD

Charging the Device
1. Assemble the AC/DC power supply, country plug and
USB type C cable.
2. Connect the USB type C cable to PM67.
3. Provide power by plugging the power supply to the
wall socket.
You can charge the device with charging cradles (Sold
separately), too.
< Caution >
1. Always use an original power supply from Point Mobile.
Other chargers and cables may damage the PM67.
The device warranty does not cover any damage caused by
the usage of non-original power supplies.
2. Make sure the charger and cable is not wet.
LED Indicator
1
2
No
Indicator
Status
Indication
1
Power
LED
Solid
red
Charging
the device (With charger)
/
Battery is low (Without charger)
Blinking
red
Charging
temperature is too low or
high
(With
charger)
/
Battery is critical low (Without charger)
Solid
green
Device
is fully charged
2
Notification
LED
Blinking
blue
Notification
existing
Red
flash
Barcode
reading failed
Blue
flash
Barcode
reading success

Scan a Barcode
Scanner is placed on the top of the PM67.
Scanner is disabled by default, so enable the scanner from
ScanSettings first.
Then, press a scan button on the device to scan a barcode.
Turn on / off
Turn on
Turn off
Press and hold the Power button on the right side of
PM67 until SMART BEYOND RUGGED logo displays on
the screen.
When the screen is on, press and hold the Power button
until the power menu is shown.
Then, tap Power off among the menu.
Center the green dot aimer or the cross-hair laser aimer over
the barcode.
The entire barcode must be inside the illumination square.
Ideal Aiming
N3601 Scanner SKU
N6603 Scanner SKU

Certification
Model: PM67
Trade name of certified: Point Mobile Co. Ltd.
Manufacturer: Point Mobile
For more certificate Information,
go Settings >About phone >Certificates