Polaris 2881979 User manual

APPLICATION
All Platforms 144'' and Longer
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for.
Please retain these installation instructions for future reference and parts ordering
information.
KIT CONTENTS
This Kit includes:
REF QTY PART DESCRIPTION PART NUMBER
1 1 Storage Bag 2687257
2 4 LOCK & RIDE®Anchor -
1 Instructions 9927083
TOOLS REQUIRED
No Tools Required
IMPORTANT
Your STORAGE BAG KIT is exclusively designed for your vehicle. Please read the installation instructions
thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to
ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 10 minutes
Instr 9927083 Rev 01 2016-07 Page 1 of 2
P/N 2881979
STORAGE BAG KIT

Instr 9927083 Rev 01 2016-07 Page 2 of 2
INSTALLATION INSTRUCTIONS
1. Assemble LOCK & RIDE®anchors properly into
each of the four mounting locations.
a. Insert T-slot anchor (A) through rubber bushing
(B).
b. Insert T-slot anchor with bushing through base
of storage bag mounting bracket (C).
c. Place both washers (D) onto top of T-slot
anchor (A).
d. Place dowel pin (E) through opening in T-slot
anchor.
e. Fully clip LOCK & RIDE®handle (F) into dowel
pin (E).
2. Place storage bag qonto tunnel and place T-slot
anchor base into tunnel slot.
3. Rotate LOCK & RIDE®handle (F) so that T-slot
anchor is perpendicular to tunnel slot.
NOTE
Handles always need to be pulled over towards
center of the tunnel as shown.
IMPORTANT
• Do not carry sharp or pointed objects inside the
bag.
• Maximum carrying capacity is 10 lbs. (4.5 kg).