Polygroup FunSicle Activity Pool User manual

1. Lay all parts (located in Boxes 2a & 2b) on the ground around the pool liner as shown below:
NOTE: For smaller pools, all metal frame and T-Fitting parts are packed in one box - number 2.
2. Slide the Horizontal Beams into the sleeves of the pool liner.
3. Connect each T-Fitting to the horizontal beams (each should snap into place).
STEP TWO: Assemble the pool frame and connect it to the liner.
This Quick Start Guide provides a simple overview to your pool’s setup process.
For detailed setup guidelines, important safety information and useful tips, refer to the
enclosed “Funsicle Activity Pool User Guide.”
Ready. Set. Play.
Activity Pool
Quick Start Guide Sign up for future
offers and discounts.
Scan the QR Code.
Locate a clean and flat level area free of stones
or sharp objects.
TIP: Let the liner sit under the sun for at least
two hours before assembling the rest of the
pool; this allows the liner material to be more
flexible, making it easier for you to attach it to
the beam frame structure.
STEP ONE: Prepare the site.
2a
2b

4. Insert the Pins down through the top of the T-Fittings until the Pins snap into place on the lower
side of the T-Fitting.
5. Carefully slide the Vertical Legs up through
the liner’s belt that runs around the middle of
the pool, and then lock each one into the hold
of the T-Fitting.
6. Continue working around the perimeter
until the entire liner is securely connected to
the frame.
7. To make sure the poles are perpendicular to
the ground (and not leaning), pull out the
vertical legs. This will make the walls straighter.
Funsicle Customer Service
Website: funsicle.com/support
Phone: [phone]FUN (888-670-4386)
Email: [email protected]
STEP THREE: Add 1 inch of water to the pool and then install filtration system.
3. Continue adding water to your pool and refer to the “Funsicle Activity Pool User Guide” for
information and best practices for using, maintaining, draining, storing and/or winterizing
your pool.
2. Install the filtration system as per the enclosed “Funsicle Skimmerplus Filter Pump User Guide.”
1. After ensuring that the drain fitting is plugged securely and the cap is in place, fill the pool
with about an inch of water. Then stop filling, and smooth out all wrinkles in the liner.