Polygroup FunSicle QuickSet Pool User manual

Locate a clean and flat level area free of stones
or sharp objects.
TIP: Let the liner sit under the sun for at least
two hours prior to installation; this allows the
liner material to be more flexible and ensure a
wrinkle-free fit.
STEP ONE: Prepare the site.
This Quick Start Guide provides a simple overview to your pool’s setup process.
For detailed setup guidelines, important safety information and useful tips, refer to the
enclosed “Funsicle QuickSet Pool User Guide.”
Ready. Set. Play.
QuickSet Pool
Quick Start Guide Sign up for future
offers and discounts.
Scan the QR Code.
STEP TWO: Lay out the liner.
1. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot
air pump. Use cold air only.
2. Check to confirm adequate air pressure. Your pool should be firm to the touch but not hard.
Do not overinflate. Refer to the enclosed User Guide for more information about air pressure.
3. Close and press the inflation valves into the unit to get a flat surface.
STEP THREE: Inflate the top ring.

Funsicle Customer Service
Website: funsicle.com/support
Phone: [phone]FUN (888-670-4386)
Email: [email protected]
STEP FOUR: Add 1 inch of water to the pool and then install filtration system.
1. After ensuring that the drain fitting is plugged securely and the cap is in place, fill the pool with
about an inch of water. Then stop filling, and smooth out all wrinkles in the liner.
2. Install the filtration system as per the enclosed “Funsicle Cartridge Filter Pump User Guide.”
3. Continue adding water to your pool and refer to the “Funsicle QuickSet Pool User Guide” for
information and best practices about using, maintaining, draining, storing and/or winterizing your
pool.