PORT GUARD User manual

Installation Guide
DEADBOLT LOCK
GUARD

Phillips head Screwdriver
Note: No drill needed
Bolt and strike Exterior Assembly Interior Assembly Screws
Step 2
Step 3
Step 5
What
you'll
need
WHAT'S INCLUDED

Manual Key
Keypad & Fob Reader
USB port
Battery cover
Battery pack
Reset button
PRODUCT OVERVIEW
FRONT PANEL BACK PANEL

EXPLOSIVE VIEW
Battery cover
Screws
Back panel
Front panel
Cable
Mounting plate
Bolt

Adjust the backset of latch (if needed)
Hold the bolt in front of the
door hole, with the latch face
A
Latch adjustmen t (only if needed)
C
If the bolt holes are centered in the door hole, no adjustment
is required. Proceed to step 2. If the bolt holes are NOT
centered, adjust latch. See "bolt Adjustment."
B
60mm(2-3/8 in)
70mm(2-3/8 in)
60mm(2-3/8 in)
1

Install Bolt
2
A B

The knob must
be vertical
Install front panel
3IMPORTANT!
outside

Connect wire connector
Note: Cable goes below deadbolt,The wire connectors can only
be connected in one way.
4

Install back panel
5
inside

6
inside
Install batteries and battery cover

7Adjust lock direction
Note : If Left handle open door : Choose *46# 123456# 1
If right handle open door: Choose :*46#123456#2
After choose ,input 123456# to check if lock unlock properly.

8Insert the key and test the installation
Install our lock on top

For any technical questions or support call us on:
800 - 219 - 2366
or email us on [email protected]
Visit us at:
www.portsmartlock.com
Port Security System LLC