Positron G1002-M User manual

Document 180-0223-001-R01
G1002-M
Self-installation Guide
WWW.POSITRONACCESS.COM
5101 Buchan Street, Suite 220,
Montreal, QC H4P 2R9 Canada
[email protected]
© Positron Access Solutions
Troubleshooting
The G1002-M has three (3) Status LEDs:
• PWR: it will be ON when connected to
a local power source. If it is OFF, please
verify you have connected the 12V wall
adapter to a working power jack.
• STA: it will be yellow while the G1002-M
is booting and then will be OFF.
• G.hn: it will be ON (green) to indicate that
the link to the Internet is UP. It will be OFF
in the link is DOWN. It will blink ON and
OFF to indicate a bad link. You can restart
the G1002-M if you see a blinking G.hn
LED. If this does not solve the problem,
please reach out to your Operator for
assistance.
G1002-M Port and LED Definition
2 x Gigabit Ethernet (RJ-45)
G.hn Port (RJ-45)
G1002-M Status LEDs
12Vdc Jack

Step 4. Connect the port labeled as GE1 (on the opposite end of the G1002-M) to your
Residential Gateway using a standard Ethernet cable (usually provided with your
Residential Gateway). Port GE1 is capable of being congured in VLAN Trunk Mode
(over 4000 VLANs). Port GE2 is congurable in VLAN Access Mode (up to 12 VLANs).
Step 2. Connect the port labeled as LINE to your telephone jack.
Step 3. Connect the 12V wall adapter to a nearby power plug and connect it to the 12V
connector of the G1002-M.
Unpacking the G1002-M
Connecting the G1002-M to
your Residential Gateway
Step 1. Find a location close to where you will
install your Residential Gateway. This
location should also be close to the
telephone jack where you will connect
the G1002-M and to a power outlet.
Power Up
The G1002-M takes less than one (1) minute to power up and establish the connection to the
Internet. The STA LED will turn solid green to indicate that the G1002-M boot sequence is
completed. The G.hn LED will turn green solid to indicate that the link is UP.
Your Residential Gateway will now be able to obtain its conguration and IP address and begin
providing access to the Internet for your in-home devices. Refer to the installation document for
your Residential Gateway if needed.
12V wall adapter
G1002-M
Step 3 Step 2
Telephone jack
Power plug
12V wall adapter
Step 4
Ethernet Cable
Residential Gateway
G1002-M