POSSWAY T2 User manual

OPERATION MANUAL
WWW.POSSWAY.COM
2022

THERE IS A RISK OF SERIOUS INJURY
Whenever you ride a board, you risk death or serious injury from loss of control, collision, and falls. To ride safely,
you must read and follow the instructions and warnings in the manual.
Always wear a helmat when riding. Avoid water, wet surfaces, slippery / uneven surfaces, steep hills, traffic,
cracks, tracks, gravel, rocks, or any obstacles that could cause a loss of traction and cause a fall. Avoid night
riding, areas with poor visibility, and small spaces.
This board has a regenerative brake function. Braking downhill on a full battery can cause a board shutdown. To
avoid this situation please ride on flat or uphill roads to reduce the battery energy before attempting a downhill.
Warning: Do not ride on side-hills or on an incline of more than 10 degress. Do not ride at speed which you would
not safely control the board. In case of wireless interface or battery error, you may need to rely on skating
techniques like foot braking of sliding to stop.
WARNING: AVOID WATER!
WARNING: RISK OF ELECTRONIC SHOCK!
Your board is not completely waterproof, you can easily go through the puddles but don’t soak the board
in the water. Water damage is not covered under the warranty.
Do not open or tamper with electronics housing, which also voids the warranty.
WARNING: PINCH POINTS!
Keep fingers, hair, and clothing away from belts, motors, wheels, and all moving parts.
READ BEFORE RIDING

PROTECT
STANCE
· Always wear a helmet.
· Find an open, flat area with clean pavement for your first ride.
· Read the warning on the skateboard and at the beginning of this manual.
· Other protective equipment is highly recommended.
· Move the throttle wheel in small increments.
· Keep a wide stance on the board.
· Keep a low center of gravity.
· Lean forward when accelerating.
· Lean backward when braking.
Follow these tips to ensure a safe riding experience:

SwitchRide ModePower On
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
If you're a beginner, please roll the throttle wheel forward gently to start with a slow
speed to avoid falling.
Accelerate
Brake
QUICK START GUIDE

BOARD DIAGRAM
Front Truck
Charging Port
Motors
Rear Truck
Heat Sink
Battery Indicator ESC
Power Button
Battery Pack Baseplate
Wheels
Deck
Bushings

REMOTE DIAGRAM
Accelerate
Throttle Wheel
Power Button
Function Key
USB-C Charging Port
Hold to Turn on/off
Click to confirm options
Display
Back/Forth
Speed
Top Speed
Speed Mode Brake Mode
Cumulate Mileage
Single Mileage
Remote Control Battery Board Battery
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 31 KM/H
FW MI+ B-MI+
BO
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging

SPECIFICATION
Board Size 945*235*130mm （37.2x 9.3x 5.1 in）
50mm
8 ply canadian maple and 1 ply Bamboo
26mph / 43kmh
Up to 30％19.4lb / 8.8kg
330lb / 150kg
Mi: 0-20km/h (12mph)
Pro: 0-43km/h （Faster acceleration）
Lo: 0-10km/h (6 mph)
Hi: 0-43km/h (26mph)
Minimum Ground Clearance
Board Material
Top Speed
Climbing Grade
Range
Weight
Max load
Wheels 90*54mm, 85 resilience, SHR83A
280.8wh 45°,7in
4 hours (2A)/1.5 hours (5A)
15-20m
40 mins
7.8Ah，36V，10S3P 18650 Li-ion Battery
30-35km (18-21mi) The range varies according to the
road, slope, and rider's weight.
Battery Type
Battery Capacity
Waterproof Rating IP54
Trucks
Board Charging Time
Remote Distance
Remote Charge Time
Ride Mode

Auto Power ON
Auto Power OFF
POWER ON / OFF
1s
10 Mins
Push the skateboard forward and after a beep, the
skateboard will turn on automatically.
When the skateboard is stationary for 10 minutes,
the power will be turned off automatically.
POWER ON/OFF THE BOARD
Press the Power Button for 1 second.
A
B

Double-click to switch marching direction.
MARCHING DIRECTION
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
BW MI+ B-MI+
BO
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Do not switch directions while riding to
avoid falling.
FW: Forward
BW: Backward

SWITCHRIDE MODE
LO: 0-10km/h (6 mph) MI: 0-20km/h (12mph)
PRO: 0-43km/h (26mph)
(Faster acceleration)
HI: 0-43km/h (26mph)
Click the  to switchRide Modeoptions.
RIDE MODE
10
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
Lo B-MI+
BO
43
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
HI B-MI+
BO
43
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
PRO B-MI+
BO
20
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
MI B-MI+
BO
Accelerate
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging

ADJUST THE BRAKE STRENGTH
B-LO
B-MI
B-HI
B-PRO
10
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW Lo B-MI
BO
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Pull the Throttle Wheel back on the remote
control and do not release it. At the same
time, short press the to switch the four
gears of the braking strength.

ADJUST SPEED UNIT
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:55
FREQUECY:2402
12
RM
ODO : 00163 KM
30 I
MPH
Max: 0 MPH
BW MI+ B-MI+
BO
Accelerate
Brake
Charging
① Turn off the remote.
② Press the button
and button to enter
setting mode.
③ Roll the throttle wheel
and adjust the speed unit.
④ Press power button to save settings.
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:55
FREQUECY:2402

SET CRUISE CONTROL
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI
BO
①Accelerate to the speed you want.
②Short press the Power button to display
CRU, and enter Cruise Control.
③Push to accelerate, brake, or press the Power
button again to exit Cruise Control.
CRU

CONNECTING (PRE-PAIRED WITH BOARD)
The board and the remote are already paired for sale, if you want to change the drive motors or other settings,
follow the steps below to do the re-connecting.
Accelerate
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
① Press the power button of the skateboard to turn on.
③Turn on the remote control .
② Long press the power button for 5-7 seconds,
after a beep, the signal light flashes to enter the
pairing mode.
The remote control and
skateboard signal light
flashes, and the pairing is
successful.
Signal Signal light
④Click the power button and button at the
same time, the connection is successful after a beep.

CHARGE THE BOARD
4hrs/2A
1.5hrs/5A
WARNING: Never leave board
unattended while charging.
After fully charged, the skateboard
indicator light changes from flashing
to solid red.
Signal light
Battery light
{
Less than 30% 30% - 70%
70% - 90% 90% - 100%

REPLACE WHEELS
THUMBNHEEI:OK
Accelerate
Brake
Charging
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:
62
FREQUECY:2402
UMIT:KM/H
WHEEI SPEED:
55
FREQUECY:2402
enter setting mode.
① Turn off the remote.
② Press the button
and button to
④ Roll the throttle wheel
and adjust the wheel speed.
③ Press button
to select wheel speed.
⑤ Press power button to save settings.
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:55
FREQUECY:2402
90mm wheels
105mm wheels

RIDING OUTSIDE OF YOUR PRIVATE PROPERTY
Abide by the laws and regulations in your state or country.
Respect other drivers and pedestrians on the road.
Avoid riding in busy traffics and crowded areas.
Do not park your board in a way that blocks people or traffic,or may create a safety issue.
Cross road at designated crosswalks or signaled intersections.
When riding with other riders,keep a safe distance from each other and other transport devices.
ldentify and keep a safe distance from hazards and obstacles on the road.
Do not ride your board on private property unless you have obtained permission.
Do frequent maintenance checks,make sure all screws are tight before riding.
Clean the bearings regularly.
Turn off board and controller when not in use.
Recharge the battery in well ventilated area.
Do not charge the battery in area with might wet the board or charging units.
Do not leave the board charging unattended. Stop using the product or charging unit if any wire is damaged.
Only use charging units supplied by us.
Do not use the board battery to power any other equipments.
PRECAUTIONS FOR USE
STORAGE AND MAINTENANCE

BATTERY SAFETY
Lithium-ion battery can explode or cause a fire if they are used incorrectly.Therefore,it is recommended to read the
following instructions very carefully:
Each time before riding the board,carefully check the battery pack and especially the protective seal.Make it is
undamaged and intact.lf in doubt,take the battery to a chemical waste disposal facility.
Never drop the board.
Store the board with battery inside in a dry place.
Never expose the battery to tempreture above 100 celsius degrees.
Only use offical board charger for charging board battery.
Never leave the board unattended when charging.
Never make the board work when charging.
Charge fully the battery before first time use.This gives it better long-term performance.
●
●
●
●
●
●
●
●
lf you are not planning to use the board for about 2 months or longer, Charge it to
at least 50% - 60% and charge it once a month. A lithium-ion battery that has
been left empty for too long no longer be charged.

WARRANTY
LIMITED WARRANTY
FOR ALL RETURN and WARRANTY SHIPPING
●
●
●
●
●
We offer 6 months (180 days) warranty on parts from the date when you receive the board.
If a defect arises during the Warranty Period, Company will , at is options :
1 ）Send the new parts to replace the defect parts.
2）Exchange the affected Products with functionally equivalent Products that are new or formed from new
and/or previously used parts that are equivalent to new in performance and reliability.
This warranty excludes damage resulting from abuse, accident, modifications, unauthorized repairs, neglect,
abuse, water damage, or other causes that are not defects in materials and workmanship.
This warranty excludes normal depletion of consumable parts (grip tape, wheels & bearings) unless due to a
defect in materials or workmanship.
This warranty excludes gifts.
Please keep your shipping box. The warranty does not include damage from shipping in insufficient packaging.
The damage of skateboard caused by immersion of water will not be within the scope of
warranty.

If the parameters are updated without notice, please refer to the official website.2021.12.31
www.possway.com After-sales service:
[e-mail]