pottery barn kids ZOEY TWIN / FULL BED User manual

Date: 2016-Feb.-24
Rev: Page 1 of 4
pottery barn kids
ZOEY TWIN / FULL BED
www.potterybarnkids.com

Date: 2016-Feb.-24
Rev: Page 2 of 4
IMPORTANT SAFETY INSTRUCTIONS:
•Please read all instructions carefully before assembling this Bed.
•For your safety, assembly by two or more adults is strongly recommended.
•Keep these instructions for future use.
•Use only vendor-supplied hardware to assemble this item. Using unauthorized hardware could
jeopardize the structural integrity of the item.
PRE-ASSEMBLY:
•Remove all parts and hardware from the box. Place all items on a carpeted or scratch-free work
surface, as this will avoid damaging parts during assembly. The shipping box provides an ideal work
surface.
•To avoid accidentally discarding small parts or hardware, do not dispose any packaging or contents of
the shipping carton until assembly is complete.
•Use the parts and hardware lists below to identify and separate each of the pieces included.
•The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
•The use of power tools to aid in assembly is not recommended. Power tools can damage the
hardware and split the wood.
PARTS INCLUDED:
(A) Headboard (x1)
(B) Footboard (x1)
(C) Side Rails (x2)
(D) Slat Roll (x1)
(E) Turned Legs (x4)
TOOLS REQUIRED (NOT INCLUDED):
Phillips Head Screwdriver

Date: 2016-Feb.-24
Rev: Page 3 of 4
HARDWARE INCLUDED:
(F) Bolt
5/16” x 2-1/2”– 8x (G) Lock washer 5/16”– 8x (H) Half-moon washer 5/16”– 8x (I) Allen key with ball tip 4 x 110 – 1x (J) Pan head screw 8x30mm – 32x
ASSEMBLY INSTRUCTION STEPS:
1. Place (A) and (B) down onto a soft, flat surface.
2. Thread (E) into the cut-outs located on the bottom posts of (A) and (B),as seen in the illustration
below.
3. Determine desired location of the bed. Attach (C) to (A &B) by aligning pre-drill holes with wooden
dowels as shown below. Do not over tighten.
Note:Only tighten once all bolts are in place to avoid misalignment.

Date: 2016-Feb.-24
Rev: Page 4 of 4
4. Extend and place (D) to bed frames and fasten each slat with (J) and Phillips head screw driver
(not provided), as shown below. Do not over tighten.
5. Assembly is completed. Carefully slide Zoey Trundle (sold separately) under the bed.
CARE INSTRUCTIONS:
•Dust often using a clean, soft, dry, and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp cloth.
•We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our
lacquered finish.
•Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
J 32x
Thank you for your purchase
Stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181