PotteryBarn Hudson Daybed User manual

Hudson Daybed
Pre-Assembly:
• Please read all instructions carefully before assembly.
• For your safety and ease to assembly the products by two people is recommended.
• Carefully lay out and identify all parts and hardware prior to assembly.
• Save all packing materials until assembly is complete to avoid accidentally discarding small parts or hardware.
Parts Included:
 BOX 1:BOX 2:
Headboard (1pc) Footboard (1pc)
 BOX 3:
Side rails (2pcs ) Slat roll (1pc) Trundle front board (1pc)
Tools Needed:
• Philips screwdriver (not provided)
Hardware included:
• (1) Allen Key (A)
• (6) 1/4”x3/4”Allen Bolts (B)
• (6) 1/4”x10mmx2mm Spring Washer (C)
• (6) 1/4”x16mmx1mm Flat Washer (D)
• (32) #8x30mm Phillip head screws (E)
Assembly Instructions:
1. Attach each side rail to the end boards by dropping the hooked ends into the corresponding slots. Be sure the
ledges of the side rails are facing inward. Figure #1.
Figure #1

2. Place slat roll on side rail ledges so the pre-drilled holes on the slat roll line up with the pre-drilled holes on the side
rail ledges. (binding should face UP). Attach the slats by inserting the Philips wood screws (E). Tighten with Phillips
screwdriver. Figure #2.
Note: If the floor is uneven, adjust the recessed levelers which are found pre-attached to the leg bottoms. Figure #3.
 Using two people, carefully grasp one side of the daybed and elevate it slightly to provide access to levelers.
 Turn the levelers until adequate contact will be made with the floor.
 Carefully set the daybed down. Repeat until the daybed sits level and is stable.
Figure #2 Figure #3
3. Hold trundle front board upright and tilted slightly towards the faceplates of the pre-assembled bed frame. Figure #4.
 Insert an (B) Allen bolt into (C) spring washer and (D) flat washer. Continue the screw through the hole in the
back of the trundle front board.
 Repeat for all pre-drilled holes.
 Tighten Allen bolts by using enclosed (A) Allen key. Periodically tighten all connections.
4. Assembly is complete. Figure #5.
Figure #4 Figure #5
Care Instructions:
• To clean, wipe with a soft damp cloth.
• Always avoid the use of chemical and abrasive cleaners.
• Wipe spills immediately.
thank you for your purchase
stores | catalog | www.potterybarn.com